Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Delta Electronics Dateigröße: 173.26 kb Dateiname: 4983900en.pdf Unterrichtssprache:

Failure to do so could cause grease deposits to build up, causing a fire hazard. 13 Maintenance and care • The hood must always be disconnected from the mains power supply before beginning any maintenance work. Opening the grid • Open the latch L and swing the grille downwards. - Fig. 6. • To remove the grid, pull it forwards from the right and • The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the external evacuation or internal recycling function. Important: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Hand washing Soak grease filters for about one hour in hot waterwith a grease-loosening cleaner, then rinse offthoroughly with hot water. Repeat the process if necessary. Refit the grease filters when it are dry. Dishwasher machine Place grease filters in dish washer. Select most powerful washing programme and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when it are dry. Note: when washing the metal grease filter in the dishwasher a slight discoloration of the filter can occur, this does not have any impact on its performance. • Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 14 Removing the filter Open the grid and remove the stops M to take out the filter. See Fig. 7. Carbon filter • The activated carbon filter should only be used if you want to use the hood in its filtering function. • To do this you will need an original AEG activated carbon filter (see special accessories). • This filter cannot be cleaned or reused. • As a general rule, the activated carbon filter should be changed once every four months. • Mounting - Fig 8 a. Fit first rearwards on the proper seats. b. Then fix frontwards the carbon filter using hooks C. • Dismounting : Unhook the carbon filter from its housing pushing hooks C. EZD • Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. • The activated carbon filter can be ordered from the AEG Service Force. 15 Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. Changing the light bulb • Disconnect the unit from the mains power supply. • Remove the grid. • Replace the old light bulb with a new light bulb (40 W max.). • If the light does not come on, make sure the bulb has been screwed in correctly before contacting the technical assistance service. Cleaning • Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor's protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use c...

Herunterladen

Geben Sie zwei Ziffern: