Stimmen - 3, Durchschnittliche Bewertung: 4.7
(
)
)
|
Anleitung Zusammenfassung
Be sure you have read and understood section 4, “Infant Restraint Location” on p.19-23. Make sure vehicle is on level ground so thatthe level indicator, which is attached to the infant restraint, can be used to properlyrecline the infant restraint ... If a front passenger seat is used, slide thevehicle seat rearward as far as possiblefrom the dashboard. If a rear seat is used, make sure the seat in front of it is moved forward enough and is upright enough toallow room for the infant restraint. 1. Remove infant restraint from base, regardless of whether or notyou plan on using the base. 2. Place the base . or infant restraint . in a rear-facing position ina forward-facing vehicle seat. .. 31 .... 3. Thread the seat belt: Base and infant restraint Infant restraint only Belt MUST go under tongue 4. Buckle the seat belt. Make sure the buckle .. tongue goes into the correct buckle ... The seat belt should not be twisted or turned. 5. Tighten the vehicle seat belt. Refer to your vehicle ownersmanuel and the instructions in “4.2.2 SAFE Vehicle Belt Systems”, p. 22-23, on tightening your vehicle belt. To create a very tight installation, push down hard with your knee or free hand in the middle of the infant restraint or base . and pull and tighten the vehicle belt. 32 .. 6. Push the infant restraint down into the base and make sure that you hear a “click” ... Pull up on the infant restraint to be sureit is latched securely into the base. If the infant restraint does not securely latch into the base, the infant restraint provides NO protection for your child. DO NOT use the infant restraint/baseif the infant restraint does not securely latch into the base. .. 33 5.4 Reclining Infant Restraint/Base For your child’s safety, it is important that your infant restraint/base be properly reclined. Attached to the side of your infant restraint is a level indicator to help properly recline the infant restraint/base on thevehicle seat. Failure to properly recline the infant restraint on the vehicle seatincreases the risk of serious injury or death. If the infant restraint is too upright, a child’s head may drop forward and cause breathingproblems. If the infant restraint is too reclined, a crash could put too much force on a child’s neckand shoulders. The infant restraint must be properly reclinedaccording to the following instructions. Check the level indicator. You must look straight on at the indicator. —If the indicator shows ONLY blue, the infant restraint is properly leveled. —If any orange is showing in the level indicator adjust the recline. 34 When using the base: To lower the foot; pull down on the bottom of the foot to the desired setting to adjust the recline ... To raise the foot; set the base on a flat surface, push in on the fingers on the base and push down on the base to adjust the .. .. recline ... If there is still orange in the level indicatorwhen the foot is completely extended thenplace a rolled towel under the foot untilONLY blue shows ... .... When using only the infant restraint, if thereis still orange in the level indicator when theinfant restraint is resting on the vehicle seatthen place a rolled towel under the infantrestraint until ONLY blue shows ... Readjust the vehicle seat belt as necessaryto secure the infant restraint firmly in thevehicle seat. 35 Final Safety Check: Every time you drive with your child, PUSH DOWN on the top of the infant restraintslowly but firmly to make sure the vehicle beltdoes not lengthen at all and that the vehiclebelt is fastened very tightly around the infantrestraint/base ... .... Holding the infant restraint near the vehicle beltpath, TWIST AND PULL the seat forward and toboth sides to make sure the vehicle belt does not lengthen or loosen and the infant restraint doesnot easily move ... 36 6.0 Additional Information 6.1 Airplane Use Install in an airplane the same way as in anautomobile. Notify the airline ahead of timethat you intend to bring the seat on board. Use only in forward-facing aircraft seat. Follow the flight attendant’sinstructions about infant restraint placement. Do not use this infantrestraint if the airplane seat belt does not hold the infant restraint tightly. 6.2 Cleaning and Maintenance TO REMOVE AND WASH INFANT RESTRAINT PAD, follow instructions in “5.1 Positioning Harness Straps”, p. 24-26. On 5-point harnessmodels, push aside thesmall tab that holds the anchor buckles in place . and pull the anchorbuckles out of their indentations. Push a corner of each anchor buckle back into its slot ... Carefully remove the seatpad. Machine wash ondelicate cycle and drip-dry. DO NOT USE BLEACH. 37 .... Reverse steps to reinstall seat pad. Check that harness system is not twisted, and pull on harness system to be sure harness is securely reinstalled. INFANT RESTRAINT METAL AND PLASTIC PARTS may be cleaned by wiping with a mild soap and water solution. DO NOT USE BLEACH. Use of bleach may weaken plastic parts. HARNESS STRAPS may be spot cleaned or replace...
Dieses Handbuch ist für folgende Modelle:Fahrräder - 6110 (3.52 mb)
Fahrräder - 6111 (3.52 mb)
Fahrräder - 6113 (3.52 mb)