Stimmen - 5, Durchschnittliche Bewertung: 4.2 ( )

Hersteller: Brinkmann Dateigröße: 428.04 kb Dateiname: 5203bdda-c498-a4c4-2102-af1fcca01081.pdf Unterrichtssprache:

Step 1 Remove nut from bottom of burner assembly. Step 2 Position the stand upside down as shown. Step 3 Place burner assembly inside stand with threaded bolt protruding through support strap as shown. Step 4 Thread nut onto bolt and securely tighten. Do not overtighten. Step 5 Set cooker with burner assembly upright on flat surface. Make sure burner assembly is securely attached to cooker. Step 6 Attach female SAE fitting on hose assembly (using w" wrench) to the male SAE fitting on the burner (using d" wrench). Hold the male SAE fitting securely with one wrench and turn the female fitting with the other wrench until they are tightly joined. All Purpose Gas Cooker Turkey Fryer Gas Cooker Rotating Air Shutter Air Hole IMPORTANTSAFEGUARD •DONOTREMOVETHISTAG• TURNGASONANDOFF USINGVALVEONL.P.GAS TANK.USETHISRED CONTROLVALVEFOR FLAMEADJUSTMENTONLY. POL Fitting Female SAE Fitting NOTE: Make sure the male SAE fitting on the cooker is screwed into the air shutter and tightened securely. Do not over-tighten as the air shutter needs to move freely in order to adjust air intake. Check the attachment for proper connection every time propane tank is connected to cooker. GAS LEAK TESTING THE GAS LEAK TESTING PROCEDURE MUST BE PERFORMED EVERY TIME THE TANK IS CONNECTED TO COOKER. WARNING • Gas leak testing must be performed outdoors in a well ventilated area. • During the gas leak testing procedure, always keep unit away from open flames, sparks or lit cigarettes. • Never use a flame to check for gas leaks. • If the burner does not light within 5 seconds, turn the propane tank valve and regulator control valve off immediately. Always wait at least 5 minutes for gas fumes to dissipate before repeating procedure. • Always use the propane tank valve to turn the unit ON and OFF. The regulator control valve is used to adjust the flame ONLY. • Never use a unit that has a gas leak. Contact The Brinkmann Corporation’s Customer Service Department for replacement parts at 1-800-527-0717. 1. Make sure the propane tank valve and regulator control valve are turned OFF. 2. Make sure male SAE fitting is properly attached to air shutter (refer to Assembly Instructions). Attach POL fitting to tank (using f" wrench) and tighten by turning COUNTER-CLOCKWISE. 3. Prepare a soapy water solution (one part dishwashing liquid to three parts water) to test for gas leaks in the hose and connections. Apply a generous amount of the soapy mixture to the regulator, POL fitting, control valve, the entire length of hose and SAE fitting (located near the air shutter). 4. With the regulator control valve in the “OFF” position, open the propane tank valve two full turns (counter-clockwise). Next, open the regulator control valve fully and check for bubbles at control valve, along the entire length of hose and at the SAE fitting. DO NOT LEAVE GAS ON FOR MORE THAN 10 SECONDS. If soapy mixture starts bubbling, gas is leaking through the connection or hose. Turn the propane tank valve OFF and retighten the connection that is leaking gas. Repeat procedure with soapy mixture until gas no longer leaks. NEVER USE A FLAME TO CHECK FOR GAS LEAKS. Turn the propane tank valve OFF after each test. 5. Once all gas leaks have been sealed, WAIT AT LEAST 5 MINUTES FOR GAS FUMES TO DISSIPATE BEFORE LIGHTING THE BURNER. CAREFULLY FOLLOW “OPERATING INSTRUCTIONS” ON PAGE 5 TO LIGHT THE BURNER AND PROPERLY OPERATE THIS UNIT. f" Wrench Propane Tank Valve Regulator NOTE:POL fittings are made with a metal to metal seal and must be made very tight to prevent leaking. Watch For Bubbles OPERATING INSTRUCTIONS PLACE THE COOKER OUTDOORS ON A HARD, LEVEL, NONCOMBUSTIBLE SURFACE AWAY FROM ANY COMBUSTIBLE MATERIAL. IN WINDY WEATHER, THE COOKER SHOULD BE LOCATED IN AN OUTDOOR AREA THAT IS PROTECTED FROM THE WIND. GAS LEAK TESTING PROCEDURE MUST BE PERFORMED EVERY TIME THE COOKER IS USED. READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY Regulator Control Valve NOTE: Due to the intense heat from burner, it is normal for paint to burn off and ...

Herunterladen

Geben Sie zwei Ziffern: