Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: GE Dateigröße: 2.47 mb Dateiname: Unterrichtssprache:

Failure to follow receptacle. DO NOT cut or remove the grounding prong from this warning can cause serious injury, fire or death. this plug. Before Setting Surface Controls Control Locations of the Gas Surface Burners Your cooktop is equipped with gas surface burners with different BTU ratings. The ability to heat food quicker and in larger volumes increases as the burner size increases. ° The small SIMMER burner is best used for simmering delicate sauces, etc. This burner is located at the right rear burner position on the cooktop. * The REGULAR burners can be used for most surface cooking needs. ° The large TURBO BOIL burner is best used for bringing large quantities of liquid rapidly up to temperature or when preparing larger Figure 1 -Model 790.3230 _ quantities of food. ° The BRIDGE burner is best suited when using rectangular or long shaped cookware. The left rear and left middle are combined and controlled by the same control knob. The left front burner may also be added for a total of 3 burners. ° The POWER burner is best used when preparing larger quantities of food and it quickly bring liquids up to a roiling boil. ° The DUAL RING burner gives precise control from 18,000 BTUs aii the way down to 600 BTUs. The small inner ring is used for optimal simmering, while both rings are used for even heat distribution and maximum power. Regardless of size, always select cookware that is suitable for the Figure 2 -Model 790.3232 _ amount and type of food being prepared. Select a burner and flame size appropriate to the pan. Never allow flames to extend beyond the outer edge of the pan. Figure 3 -Model 790.32353 & C970-40610 Figure 4 -Model 790.3233 _ Figure 5 -Model 790.3231 _ Before Setting Surface Controls Burner Cap Fixed Burner Head \ \ •Gas Opening Assembly of the simmer, regular, power and turbo boil surface burner caps and burner grates It is very important to make sure that all of the Surface Burner Caps and Surface Burner Grates are installed correctly and at the correct locations. 1. Remove aii packing material from cooktop area. 2. Discard all packing material (if applicable). 3. Position the burner caps in the correct position. 4. Unpack Burner Grates and position on the cooktop. Note: Burner heads are fixed. Do not try to remove them. REMEMBER m DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS OPENING. Always keep the Burner Caps in place whenever the surface burners are in use. Burner Caps Figure 1 Dual Ring Burner Head Assembly Maize sure that the Burner Caps and Burner Grates are installed properly and at the correct locations. 1. Remove aii packing tape from cooktop and the dual burner. 2. Discard aii packing material located under aii Burners (if applicable). Fixed Burner Head 3. To install Burner Caps, refer to figure 2 and maize sure both caps are aligned properly with the burner head. 4. Put back the grates on the cooktop. REMEMBER--DO NOT ALLOW SPILLS,FOOD, CLEANING AGENTS OR ANY OTHER MAT...

Herunterladen

Geben Sie zwei Ziffern: