Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Dacor Dateigröße: 337.63 kb Dateiname: Unterrichtssprache:

Note: Ask your dealer about the DACOR AMG11 Griddle. This Griddle is designed for the DACOR bridge burner. .............................................................................................................................. .................................................................................................................... Bridge Burner Control Switch Selecting Proper Cookware For best results, a few simple guidelines should be followed: use medium to heavy gauge metal cookware with flat, thick and smooth bottoms for greatest efficiency. Glass cookware should only be used as recommended by the cookware manufacturer. IMPORTANT: In no instance should a support, such as a wok ring or trivet, be placed directly on the cooking surface. This may result in scratching of the glass ceramic top. WARNING: To avoid electrical shock or burns, turn off all controls and ensure the cooktop is cool before cleaning. IMPORTANT: Do not use harsh or abrasive cleaning agents, waxes, polishes, or commercial cooktop cleaners to clean the cooktop. Care & Cleaning Instructions Glass Ceramic Top Clean the top surface thoroughly before operating the cooktop for the first time. Apply about 1/4 teaspoon of non-abrasive cleaner, such as the Cooktop Cleaning Creme supplied, to the surface of the ceramic glass with a lightly dampened clean cloth. Use a second clean cloth to remove any remaining cleaner residue. Wipe the cooktop surface with a dry cloth to completely eliminate any remaining moisture. The cooktop surface should be maintained by repeating the above procedure during or after each use. Be careful not to wipe or clean any hot areas to avoid personal injury. It should be safe to clean each element area whenever the corresponding element residual heat indicator light has gone out. To remove heavy or burned-on spills, allow the cooktop to cool. Using a razor blade scraper held at a 30° angle to the cooktop surface, gently scrape off any burned-on substances. Remove any remaining residue by applying the recommended cleaner as described above. Be careful not to scratch or gouge the surface. Do not allow the scraper handle to touch the cooktop surface when hot. Remove any residue by applying the recommended cleaners. Pitting of the ceramic glass is possible if sugar spills or spills with a high sugar content are left in the hot zone. Use a razor scraper to move the spill to a cool area for cleaning after the cooktop cools. Troubleshooting Unnecessary service calls may be expensive, frustrating and time-consuming. Before you call for service, please review the potential problems, possible causes and remedies shown in Table 1. ProblemPossible Cause Remedy Nothing works Cooktop not connected to proper Have electrician verify that the proper rated cooktop electrical circuit. voltage is being supplied to the cooktop. Fuse is blown or circuit breaker is Have electrician replace fuse or reset circuit breaker. tripped. No electricity to the cooktop. Have electrician check your power supply. Cooktop is in lockout mode. Unlock the cooktop. Heating elements do not Cooktop is connected to 120 volt Have electrician connect cooktop to the proper rate heat properly.power supply. cooktop voltage. Power supply connection is loose. Have electrician tighten the connections at the junction box. Improper cookware is being used. Select proper cookware as outlined in the Cooktop Operation section of this manual. Heating elements cycle off Heating element temperature limiters This is a normal operating condition, especially even when elements are are temporarily shutting off the elements during rapid heat-up operations. The element turned to their highestdue to exceeding the maximum will cycle back on automatically after it has settingsallowable temperature. cooled sufficiently. Glass ceramic surface is Under direct or bright lighting, you will These are normal properties of black ceramic glass see-through or appears tosometimes be able to see through the panels. be red in color.glass and into the chassis due to its transparent quality. You may also notice a red tint under these conditions Product Maintenance No maintenance, other than the CARE AND CLEANING INSTRUCTIONS identified in this Use & Care Manual, should be attempted by the owner/operator. All other maintenance and service must be performed by a qualified appliance technician. WARNING: To prevent injury or permanent damage to the cooktop, avoid: 1. Using the cooktop as a cutting board. 2. Sliding rough-bottomed cookware, especially aluminum, across the glass surface. (Remove any resulting marks immediately, using the recommended cleaner if this occurs.) 3. Allowing anything that melts easily, such as plastic objects, aluminum foil, sugar, and foods with high sugar content, to directly come in contact with the glass surface. In the event that this condition occurs, remove from hot zone immediately with the razor scraper. 4. Placing food directly on the cooktop surface when ...

Herunterladen

Geben Sie zwei Ziffern: