Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Fisher & Paykel Dateigröße: 2.08 mb Dateiname: Unterrichtssprache:

Be sure all controls are turned to OFF and burner grates Gas Valve are cool before removing cooktop burner units. Burner Orifice Support To Remove Burner Assemblies 1. Remove the shipping screw from the support brackets. See illustrations for location of screws. 2. Grasp the burner head and tilt it slightly (A in Figure 1) to the right to release the tab from the burner support. 3. Lift up the support bracket (see Figure 2) slightly and pull it away from the front of the cooktop to free the air Air Shutter shutter from the gas valve orifice (B in Figure 1). Tab Shipping Check the lighter and burner ports (Figure 2). If they are Screw clogged, use a wire or needle to clear them. To remove burned-on food, soak the burners in a vinegar Figure 2 and water solution for 20-30 minutes. For stubborn stains, scrub with soap and water or a mild abrasive cleanser and Ports Shipping a damp cloth. Do not wash burners in a dishwasher. Screws To Replace Burner Assemblies 1. Slide the air shutter over the gas valve orifice (Figure 1). I 2. Lower the burner assembly and hook the tab in the slot Flash Tube in the burner support. Make sure the burner assembly is properly seated and level. 3. Be sure both tabs are in the correct slots, the burner Lig sits level and straight, and the flash tube forms a straight line from the igniter to the burner (Figure 2). Support 4. Replace shipping screws if desired. These screws are Brackets not necessary for the operation of the burner. They stabilize the burner during shipping of the appliance. Retain the screws for later use in the event the range is moved. Burner Support Pilot or Igniter 12 General Care & Cleaning Sealed Burner Models (somemodels) To Clean the Burner Grates, Contoured Burner Pans, Burner Cap and Burner Base The burner grates, contoured burner pans, burner caps and burner base should be routinely cleaned. Keeping the burner ports clean will prevent improper ignition and an uneven flame. See instructions below. To Clean the Burner Grates Be sure burners and grates are cool before you place your hand, a pot holder, cleaning cloths or other material on them. The cast iron burner grates can be washed in hot soapy water. Rinse thoroughly and dry the grates with a cloth; don't put them on the cooktop while still wet. Be sure the grates are positioned securely over the burners. To remove burned on food, place the grates in a covered container or plastic bag. Add 1/4 cup ammonia and soak for 30 minutes. Wash, rinse well and dry. An abrasive Burner grate can appear in cleaner can be used for stubborn stains. different shapes. To Clean the Contoured Burner Pans The burner pans are removable from the cooktop. The burner pan forms a recessed well area located around each burner unit. If spill occurs on it, after the burners are turned off, rinse with water and wipe dry. To Clean the Burner Cap Burner Cap ) Remove burner cap. Use soap-filled pad or mild abrasive cleanser to clean burner caps. If necessary, cover stubborn ...

Herunterladen

Geben Sie zwei Ziffern: