Stimmen - 1, Durchschnittliche Bewertung: 5 ( )

Hersteller: Hotpoint Dateigröße: 2.07 mb Dateiname: 678c4d68-0bf7-46b7-bea8-6e79898f4fd0.pdf Unterrichtssprache:

Note: If no further pads are touched within 10 seconds the request to power the element ON will clear. Figure 5 4. Select the FRONT (See Figures 3 & 4), +BRIDGE (See Figures 5 & 6) or ALL 3 elements ,,C All (See Figures 7 & 8) to heat by pressing the _!} pad once, twice or three times. When the bridge is set to ALL setting, the display of the left rear element changes to reflect the I @+Bridge same setting as the left front element. w (_}_ Front 5. Touch HI @ pad once to turn ON the power levelto HI. Touch Lo @ pad once for Lo. 6. Each touch of the HI or Lo pad will decrease or increase the power level Figure 7 Figure 8 from 9.5 through 3.0 by .5 increments. Simmer power levels between 3.0 and 1.2 will decrease or increase by .2 increments. Lo is the lowest power level available. Note: The power level may be adjusted at any time while the element is ON. 7. Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking. Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area. J 8. When cooking has been completed touch the (on/of_pad once to turn the element OFF and if no other surface element is used touch the P_-wE'_key pad to turn off he cooktop. Note: The HE (hot element) message will remain ON if the cooktop is still hot and will remain ON until the heating surface area has cooled sufficiently. Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently. Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it isin use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements. Warm & Hold Feature The Warm & Hold feature may be used with any of the Cooking Elements. To Turn the Warm & Hold Feature ON: 1. To select the Warm & Hold feature for any Cooking Element touch the _o_/o_f}key pad for the corresponding Cooking Element. Fig. 9 2. Touch the _ key pad located in the main control area. The associated display will show LH (low heat -Fig. 9) indicating that the Cooking Element is properly set to Warm & Hold. If no other key pads are pressed the control will activate the desired Cooking Element at the Warm & Hold setting. 12 Setting Surface Controls (cont'd) Sabbath Feature Mode When the Sabbath feature is ON, all electronic surface element control displays show "Sb" (Fig. t). The surface elements can be used even if the Sabbath Feature is on. To activate the Sabbath Feature Mode: _ Fig. t in order to enter Sabbath at least one radiant burner has to be active. The user has to activate the Timer (timer up slew) pad and the _ (lock) pad at the same ti...

Herunterladen

Geben Sie zwei Ziffern: