Stimmen - 2, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Philips Dateigröße: 2.31 mb Dateiname: Unterrichtssprache:

1 2 3 Shot of Steam (GC2225, GC2220, GC2215, GC2130, GC2125, GC2120, GC2115 and GC2110 only) A powerful shot of steam helps to remove very stubborn creases. The Shot-of-Steam function only works at temperature settings between 2 and MAX. 1 Press and release the Shot-of-Steam button. ENGLISH C C Vertical Shot of Steam (types GC2225, GC2220, GC2215, GC2130, GC2125, GC2120 and GC2115 only) 1 The Shot-of-Steam function can also be used when you are holding the iron in vertical position.This is useful for removing creases from hanging clothes, curtains, etc. Never direct the steam towards people. Drip Stop (types GC2225, GC2220, GC2130 and GC2125 only) This iron is equipped with a drip stop function: the iron automatically stops steaming when the temperature is too low to prevent water from dripping out of the soleplate.When this happens you will hear a click. Automatic shut-off (types GC2225 and GC2130 only) Pick up the iron or move it slightly. The red auto-off pilot light will go out.The amber temperature pilot light will go on, depending on the soleplate temperature. If the amber pilot light goes on after the iron has been moved, wait for it to go out before you start ironing. If the amber light does not go on after the iron has been moved, the iron is ready for use. An electronic safety device will automatically switch the heating element off if the iron has not been moved for a while. . To indicate that the heating element has been switched off, the red auto-off pilot light will start blinking. To heat up the iron again: 1 2 3 4 Cleaning and maintenance Calc-Clean The Calc-Clean function removes scale and impurities. Use the Calc-Clean function once every two weeks.If the water in your area is very hard (i.e. when flakes come out of the soleplate during ironing), the Calc-Clean function should be used more frequently. 1 Set the steam control to position O. 2 Fill the water tank to the maximum level. Do not pour vinegar or other descaling agents into the water tank.. C 3 Set the temperature dial to MAX. 4 Put the plug in the wall socket. 5 Unplug the iron when the amber pilot light has gone out. 6 Hold the iron over the sink and set the steam control to position 1 (Calc-Clean).The steam control knob will spring up slightly. C 7 Pull the steam control knob upwards to remove the steam control needle. C 8 Move the iron to and fro. B Steam and boiling water will come out of the soleplate. Impurities and scale (if any) will be flushed out. C 9 Use vinegar to remove scale, if any, from the needle. Do not bend or damage the steam control needle. C 10 Put the steam control needle back by inserting the point of the needle exactly in the centre of the hole and by fitting the small projection on the side of the needle into the slot. Set the steam control knob to position O. 11 Repeat the Calc-Clean process if the iron still contains a lot of impurities. After the Calc-Clean process 1 Plug the iron in to let the soleplate dry up. 2 Unplug the iron when the a...

Herunterladen

Geben Sie zwei Ziffern: