Stimmen - 1, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
1 Open the water inlet cover located on the front of the iron. 2 Holding the iron at a slight angle; fill the tank with the filling flask without going over the “MAX” line. Close the water inlet cover. 3 Plug in the iron. 4 Choose dry or steam ironing based on the type of fabric you are going to iron. For DRY ironing set the steam control dial to “0”. For STEAM ironing set to desired steam for the type of material to be ironed. 5 Set the desired fabric/temperature by pressing the Electronic Temperature Control on the top of the handle. 6 The temperature indicator light on the LED Display Panel will flash as the iron reaches the preset temperature. 7 Allow approximately 2 minutes for the iron to heat up or cool down to the new temperature setting. Start ironing! 1 TOLL FREE: 1-800-798-7398 you forpurchasing theShark® Rapido™ Electronic IronTECHNICAL SPECIFICATIONS120 Volts, 60 Hz., 1500 Watts Getting StartedUsing things first, remove any labels, stickers or tags that may be attached to your Shark® Rapido™ Electronic Iron. FIRST THINGS FIRST, YOU NEED TO KNOW WHAT’S IN THE BOX YOU JUST OPENED: a Shark® Rapido™ Electronic Ironb Filling flaskFEATURES: 1 Stainless Steel Soleplate Provides maximum glide-ability and heat retention. 2 Water Inlet Door Keep closed during use to prevent any water from spilling while ironing. 3 Steam Burst Button Removes stubborn wrinkles from denim, cotton or linen by surge of steam. 4 Electronic Temperature Control Select the fabric/temperature setting. 516273942ab8110121113 DRY ironing on a low temperature is best on acrylic, nylon, polyester, silk and wool. Using Your IronUsing IRONING1 Choose any of the fabric settings on the LED Display Panel according to your garment label (as described on page 8). 2 Turn the Steam Control Dial to “0”. 3 Place the iron on its heel, standing up and on a stable surface while it’s heating up to the desired temperature. 4 Once the steam flow is cut off, you can start ironing. STEAM IRONING1 Open the water filling inlet cover. Holding the iron at a slight angle, pour the water slowly into the inlet. The soleplate design allows for ordinary tap water to be used. We recommend using the mix of 50% tap water and 50% distilled water to reduce the hardness. 2 Using the filling flask, fill the tank to a desired level without going over the “MAX” line on the water tank. 3 When you’re finished, close the inlet cover before continuing. 4 Plug the cord into a polarized 120V AC electrical outlet. 2462571 Steam burst helps to remove stubborn wrinkles and can work both horizontally and vertically. Using the Burst of Steam ButtonElectronic Make sure the water tank is at least 1/2 filled with water. 2 Select the desired fabric and tempera- ture setting after reading the garment label. 3 Place the iron on its heel, standing up on a stable and protected surface so it can heat up for approximately 2 minutes. 4 Press the steam burst button while holding the iron horizontally or vertically....
Dieses Handbuch ist für folgende Modelle:Bügeleisen - GI468CN 12 (2.53 mb)
Bügeleisen - GI468N 12 (2.53 mb)
Bügeleisen - GI468N 10 (2.53 mb)