Login:
Stimmen - 0, Durchschnittliche Bewertung: 0 ( )

Anleitung HP, modell HP StoreEver MSL6480 Scalable Base Module

Hersteller: HP
Dateigröße: 437.98 kb
Dateiname:
Unterrichtssprache:en
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite



Dieses Gerät hat auch andere Anweisungen:

Anleitung Zusammenfassung



HP StoreEver MSL6480 Tape
CAUTION:
Parts can be damaged by
Library OCP, Bezel, and
electrostatic discharge. Keep parts in
electrostatic containers until needed. Ensure you
Magazine Access Doors
are properly grounded when touching static
Replacement
sensitive components.
NOTE:
The OCP (operator control panel) is
only attached to a base module bezel; the OCP
Abstract
is not included on an expansion module bezel.
The bezel and doors are mandatory customer self repair
This replacement kit may contain components
parts. HP customer self repair (CSR) programs allow you to
that you do not need; only replace those
repair your StoreEver product. If a CSR part needs
replacing, HP ships the part directly to you so that you can
components that are necessary. This document
install it at your convenience. For more information about
may describe components not included in your
CSR, contact your local service provider. For North America,
kit.
see the CSR website: www.hp.com/go/selfrepair
Powering off the library
NOTE:
Power off the library if you are
replacing a bezel. If you are only replacing
doors, skip this step.
1.
Verify that any applications using the library are
idle.
2.
Press the power button just below the OCP and
hold for three seconds; the green light will go off.
NOTE:
Under normal circumstances, when the
library is powered off using the front power
button the robot automatically parks and locks
into the base module behind the OCP.
Removing the bezel
1.
Open the magazine access doors.
2.
On one side of the bezel near the top, insert a
small flat head or Torx screwdriver into the bezel
© Copyright 2013 Hewlett-Packard Development Company, L.P.
release hole.
3.
Push the screwdriver gently toward the middle of
the bezel until that corner of the bezel is released.
4.
Release the other top corner in the same manner.
5.
Pull the bezel up until clear of the bottom brackets.
NOTE:
If removing a base module bezel,
pull gently to avoid damaging the OCP
HP Part Number: QU625-96302
cable. Note where the OCP cable is
Published: June 2013
Edition:
*QU625-96302*
located, routed, and attached.
Page 1


...


Bewertungen



Bewerten
Vorname:
Geben Sie zwei Ziffern:
capcha





Kategorien