Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Welch Allyn Medical Diagnostic Equipment Dateigröße: 315.14 kb Dateiname: 798fb69e-0307-414e-966c-f23f56d01128.pdf Unterrichtssprache:

Welch Allyn shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. This document contains proprietary information which is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of Welch Allyn, Incorporated. 1999 Welch Allyn, Inc. All rights reserved. Welch Allyn shall not be liable for use of our product with equipment (i.e., power supplies, personal computers, etc.) that is not CE marked and does not comply with the Low Voltage Directive. The CE mark on the product indicates that the system has been tested to and conforms with the provisions noted within the 89/336/EEC Electromagnetic Compatibility Directive and the 73/23/EEC Low Voltage Directive. C.S.A. Statement This product must be used with a certified Class 2 power supply or be powered by a certified SELV (Safety Extra Low Voltage) output. RF Approvals This product complies with the following: U.S.A. FCC Part 15.249 Certified Australia C–TIC Canada RSS 210 Certified Europe ETS 300 328 Certified Mexico NOM–EM–121–SCT1–1994 Certified Singapore Type Approval for Spread Spectrum System Safety Approvals U.S.A. UL Listed, C22.2 No. 950 / UL 1950 Australia conforms to AS/NZS Canada 3548cUL Listed Europe TUV Rheinland GS Licensed, EN 60950 (IEC 950) (Scanner and Base only, not on battery) Mexico NYCE Certified, NOM 19 TABLE OF CONTENTS Cordless Scanner Quick Start Guide Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 About the Battery Pack . . . . . . . . . . . . . . . . . . . . . 2 ChargingYour Battery Pack . . . . . . . . . . . . . . . . . 3 Associating the Cordless Scanner to a Base . . 4 Obtaining Factory Service . . . . . . . . . . . . . . . . . . 5 Technical Support . . . . . . . . . . . . . . . . . . . . . . . . . 6 Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Limited Warranty Durations . . . . . . . . . . . . . . . . . 6 Sample Bar Codes (back cover) Cordless Quick Start Guide This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Class B Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio or television technician for help. Caution: Any changes or modifications made to this device that are not expressly approved by Welch Allyn, Inc. may void the user’s authority to operate the equipment. Note: To maintain compliance with FCC Rules and Regulations, cables connected to this device must be shieldedcables, in which the cable shield wire(s) have been grounded (tied) to the connector shell. Canadian Notice This equipment does not exceed the Class B limits for radio noise emissions as described in the Radio Interference Regulations of the Canadian Department of Communications. Le present appareil numerique n’emet pas de bruits radioelectriques depassant les limites applicables aux appareils numeriques de la classe B prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communications du Canada. CDRH Laser Safety Statement This product complies with US DHHS 21 CFR J Part 1040.10. This product is a CLASS II LASER PRODUCT with a maximum output of 1.0 mW at 670 nanometers and continuous wave. EN 60825–1 Laser Safety Statement This product is classified as a CLASS 2 LASER PRODUCT with a maximum output of 9.0 mW at 670 nanometers per EN 60825–1:1994, Issue 2, June 1997. Cordless Quick Start Guide Introduction The Cordless Scanning System consists of the SCANTEAM 2070 Base unit and at least one SCANTEAM 3470 Cordless CCD or SCANTEAM 5770 Cordless Laser Scanner. Up to nine scanners may be associa...

Herunterladen

Geben Sie zwei Ziffern: