Stimmen - 4, Durchschnittliche Bewertung: 4 ( )

Hersteller: Toshiba Dateigröße: 4.31 mb Dateiname: Unterrichtssprache:

See the connection information on pages 13–18. The G-LINK connection is necessary to enable the following features of your TV Guide On Screen™ system: •If you have a Cable box, you need to connect the G-LINK cable from the Cable box to the G-LINK jack to receive the TV Guide On Screen system’s program listings for your Cable service. •If you have a VCR, you need to connect the G-LINK cable from the VCR to the G-LINK jack to use the TV Guide On Screen system’s recording features. Front of Cable box To connect to the G-LINK jack: 1. Locate the infrared sensor on the front of your VCR or Cable box. The sensor is marked on some devices.* 2. Align one of the G-LINK (IR blaster) cable’s wands about 1 inch away from the infrared sensor on the front of the VCR and attach it using double-sided mounting tape. If you have a Cable box, attach the other wand in a similar manner. (See illustration at right.) Note: If you do not have a Cable box, coil the second wand with a rubber band and leave it behind the TV. 3. Plug the G-LINK (IR blaster) cable’s plug into the TV’s G-LINK jack. For details on setting up the TV Guide On Screen system: See Chapter 5. For details on using the TV Guide On Screen interactive program guide: See Chapter 7. OUT IN AUDIO IN S-VIDEO VIDEO 1 VIDEO 2 L R OUT 1 G-LINK HDMI IN DIGITAL AUDIO OUT TheaterNet ANT (75 ) ANT1 (CABLE) ANT2 CableCARD™ COLOR STREAM HD-1 COLOR STREAM HD-2 VAR AUDIO R L TheaterNet OUT 2 1 2 S-VIDEO IEEE1394 EJECT L/ MONO AUDIO VIDEO R L/ MONO AUDIO VIDEO R L/ MONO AUDIO VIDEO R PB PR Y L AUDIO R PB PR Y L AUDIO R Back of TV Front of VCR Infrared sensor G-LINK (IR blaster) cable wand (approx. 1 inch from device) *If you cannot locate the device’s infrared sensor: 1. Turn OFF the device. 2. Starting at the lower left corner of the device, place the end of the device’s remote control (with the infrared emitter) so it touches the front of the device and press POWER. (Do not use the TV’s remote control for this step.) 3. If the device turns on, the place the remote control touched the device is the location of the sensor. 4. If the device does not turn on, move the remote control slightly to the right and press POWER again. 5. Repeat step 4 until you locate the device’s infrared sensor. Copyright © 2004 TOSHIBA CORPORATION. All rights reserved. 25 H94(E)012-25(2B-Cnct) 25 8/4/04, 12:36 PM (E) 51/57H94 3 Using the remote control Learning about the remote control The buttons used for operating the TV only are described here. For a complete list of the remote control’s functions, see the remote control functional key chart on pages 28–29. POWER turns the TV on and off. SLEEP accesses the sleep timer (page 87). LIGHT The first press of the LIGHT button lights the keypad and turns on the Illumination mode. With the Illumination mode on, pressing any other key lights the keypad for 5 seconds (10 seconds if you’re in programming mode). Subsequent presses of the LIGHT butto...

Herunterladen

Geben Sie zwei Ziffern: