Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
They are available at most electronic stores. For cable or antenna with coaxial lead: 3. Connect the incoming cable to ANT-A on the TV back panel. 14 NOTE: This TV will only be able to provide an analog signal through ANT-A on the TV back panel. Connecting an Antenna to a Cable Box or VCR Note: The TV back panel and connections shown here are for reference only and may vary by model. TV back panel (section detail) Incoming Cable t t m Cable Box back panel section Figure 3. Connecting the cable box that does not have audio or video outputs. Note: See page 5 for Outdoor Antenna Grounding TV back panel (section detail) LOOP ANT-A OUT ANT-B IN OUT -AUDIO OUT ^ ÆDôïnI /-VIDEOOUT-Ï .0i iwo R 1^ Figure 4. Connecting the VCR with antennas or wall outlet table. Cable Box (Figure 3) 1. Connect the incoming cable to ANT-A on the TV back panel. Connect two coaxial cables as follows: 2. One from LOOP-OUT on the TV back panel to IN on the cable box back panel. 3. One from OUT on the cable box back panel to ANT-B on the TV back panel. NOTE: If your cable box has separate audio/video outputs, please see Composite Video with Audio or S-Video with Audio, page 16 (Figure 6). Antenna or Wall Outlet Cable (Figure 4) 1. Connect the incoming cable to ANT-A on the TV back panel. Connect two coaxial cables as follows: 2. One from LOOP-OUT on the TV back panel to ANTENNA IN on the VCR back panel. 3. One from VCR back panel ANTENNA OUT to ANT-B on the TV back panel. NOTE: If your cable box has separate audio/video outputs, please see Composite Video with Audio or S-Video with Audio, page 16 (Figure 6). Note: If you have a digital cable box, refer to your Digital Cable Box owner’s guide for instructions on optimal connections to this TV. Note: For models WS-48413. WS-55413and WS-65413. when the Energy Mode is set to Low, the VCR may not record programs when the TV is off. 15 Connecting an Antenna to a Cable Box and VCR, Connecting Audio/Video to the Cable Box or VCR Note: The TV back panel and connections shown here are for reference only and may vary by model. TV back panel (section detail) Cable Box (Figure 5) Figure 5. Connecting the VCR with cable box. 1. Connect the incoming cable to ANT-A on the TV back panel. Connect three coaxial cables as follows: 2. One from LOOP-OUT on the TV back panel to IN on the back of the cable box. 3. One from OUT on the back of the cable box to ANTENNA IN on the VCR back panel. 4. One from ANTENNA OUT on the VCR back panel to ANT-B on the TV back panel. NOTE: For best performance, please see Composite Video with Audio or S-Video with Audio, below. TV back panel (section detail) a (Recommended if available) q Attach only one cable type VCR back panel If your VCR has a video channel or RF ON/OFF switch, set to OFF.
Fernseher - ws-48413 (4.66 mb)
Fernseher - ws-48413 (4.66 mb)
Fernseher - ws-48413 (4.66 mb)
Fernseher - ws-55413 (4.66 mb)