Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Hersteller: Haier Dateigröße: 256.48 kb Dateiname: 832b34bf-ecee-4d7a-8c7e-d95ed42f99a0.pdf Unterrichtssprache:

Check that lint screen is clean and in place. Load the dryer. • The average load will fill the drum 1/3 to 1/2 full. Items need room to tumble freely for even drying and less wrinkling. Do not overload dryer. • When drying large items, dry only 2 or 3 at a time. Fill out the load with small and medium sized items. • For delicate or very small loads, add 2 lint-free towels for better drying, less wrinkling, and to prevent grease stains caused by fabric softener sheets. • Do not overdry items. Overdrying can cause wrinkling, shrinkage, harshness, and a build-up of static electricity, which can produce more lint. • If desired, add a dryer fabric softener sheet. Close the dryer door and set dryer controls (some models). See Operating Instructions card for your specific model controls. Turn cycle selector clockwise to the desired setting. Start the dryer. • Turn the START knob clockwise to ON. Hold for 1-2 seconds and release. • To add or remove items when the dryer is running, open the door. The dryer will always stop when the door is opened. Allow the drum to come to a complete stop before reaching inside. • To restart dryer, close the door then turn the START knob clockwise to ON. Hold for 1-2 seconds and release. When the cycle ends, remove items immediately and hang or fold. If load is removed before the cycle ends, turn cycle selector to OFF. Follow fabric care label instructions. 2. 3. 4. 7. Fill dryer drum 1/3 to 1/2 full. Place small items in a mesh bag. 4 Features Cycle Signal Control (some models) When the Cycle Signal Control is On, a signal will sound at the end of each cycle and during the Fabric Sentry setting (some models). The volume is adjustable on some models. Drum Light (some models) A drum light will come on whenever the door is opened to illuminate the dryer drum during loading and unloading. Closing the door turns off the light. Reversible Dryer Door Your dryer is equipped with a reversible door. The door can be hinged on the right or left side. Refer to the INSTALLATION INSTRUCTIONS for directions on changing Use the drying rack to dry items which should not be tumble dried. Open the dryer door and remove the lint screen. Insert drying rack into the dryer drum. Place the front bar under the lip of the Place items to be dried on top of the rack. Weight should not exceed 10 lbs. Leave space between items, but do not let items hang over the sides or through the grids. Do not tumble other items when using the drying rack. Select a timed dry setting best suited for items being dried. Use only the Air Fluff (no heat) temperature setting for items containing plastic, foam rubber, rubberlike materials, feathers or down. When items are dry, remove the rack and replace the lint screen. If lint screen is not in place, tumbling items could enter the exhaust system and cause Place the front bar under the lip of the lint screen opening. the door. Drying Rack (some models) lint screen opening. 4. 5. damage to the dryer. Common Drying Problem...

Herunterladen

Geben Sie zwei Ziffern: