Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
Use the jug supplied. If the water tank filter is dirty a clean the filter in the water tank. See page 4. 4. Pour the distilled water into the filling hole on the water tank, until the u symbol goes out on the display panel. If drying the recommended load, approximately 250 to 300 ml of distilled water is used in the Steam Dry -Steam Refresh programmes. 5. Insert the condensation container all the way. 6. Start the Steam Dry or Steam Refresh programme. 9 10 Installation . Scope of delivery: dryer, installation and instruction manual, jug, basket for woollens (depending on the model). . Check dryer for transport damage. . The dryer is heavy. Do not attempt to lift it on your own. . Be careful to avoid sharp edges. . Do not install in a room where there is a risk of freezing. Freezing water may cause damage. . If in doubt, have the appliance connected by a specialist. . Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage. Setting up the dryer . The appliance plug must always be accessible. . Ensure that the appliance is installed on a clean, level and firm surface. . Keep the cooling grille on the front of the dryer clear. . Keep the area around the dryer clean. . Level the dryer using the threaded feet. Use a spirit level. . Do not remove the threaded feet under any circumstances. Mains connection see safety information .. page 13. . Connect to an AC earthed socket. If in doubt, have the socket checked by a specialist. . The mains voltage and the voltage shown on the rating plate (.. Page 11) must be the same. . The connected load and necessary fuse protection are specified on the rating plate. Converting the installed load Note the fuse protection of the socket. 10/16 Amps Frost protection / Transport Preparation 1. Empty the condensation container .. page 4. 2. Select any programme using the programme selector. 3. Press the .. (start/stop) button .. condensation is pumped into the container. 4. Wait 5 min., and then empty the condensation container again. 5. Turn the programme selector to 0. The water tank must not contain any distilled water. If necessary, run the Steam/Refresh programme. 1. Remove all accessories from the drum. The drum must be empty. Make sure that the air inlet remains unobstructed Clean and level Do not install the dryer behind a door or sliding door, which could prevent or restrict opening of the dryer door. This will prevent children from locking themselves in and putting their lives in danger. 2. 3. turn to O Press and hold selection then turn 3 x to the right Set turn to O amperage 1 x to the right Feedback: 10A 16A Do not operate the dryer if there is a danger of frost. 11 Technical data .. Dimensions (DxWxH) 60 x 60 x 85 cm (adjustable height) Weight approximately 43.5 kg Max. capacity 8 kg Condensation container 4.0 l Water tank approx. 0.4 l Connection voltage 220-240 V Connected load max. 2,800 W Fuse protection 10 A / 16 A Ambient temperature 5 - 35 °C Product number Production number Inside of door The rating plate can be found on the back of the dryer. .. Consumption rates These are guide values determined under standard conditions. Fluctuations up to 10% are possible.The value on the label is achieved at the maximum heat setting. Spin speed in rpm (residual moisture) Drying time in min.** Energy consumption in kWh** .... Cottons 8 kg 10 A 16 A 10 A 16 A ... Cupboard Dry 1400 (approx. 50 %) 131 105 3.74 3.74 1000 (approx. 60 %) 148 122 4.49 4.49 800 (approx. 70 %) 165 139 5.17 5.17 .. Iron Dry 1400 (approx. 50 %) 109 83 2.24 2.24 1000 (approx. 60 %) 126 100 3.44 3.44 800 (approx. 70 %) 143 117 3.86 3.86 .. Easy-Care 3.5 kg 1000 45 39 1,05 1,05 ... Cupboard Dry 800 (approx. 40 %) 48 42 1.35 1.35 600 (approx. 50 %) 60 51 1.65 1.65 *Test programme to DIN EN 61121 **The values may differ from those given, depending on overvoltage and undervoltage, the type of fabric, composition of the laundry to be dried, the residual moisture in the fabric and the size of the load. .. Drum interior light (bulb E14, 25 W) The drum is illuminated after the door is opened or closed, and after the programme has started. The light goes out automatically. To change the bulb .. page 12. Optional accessories (order from the after-sales service using the order number) Connecting kit for condensation outlet The condensation is drained off immediately via a hose. Washer-dryer stack connection set The dryer can be stacked on top of a suitable washing machine of the same depth and width, to save space. The dryer must be secured to the washing machine with this connection set. Installation underneath the worktop Instead of the appliance covering plate, you must have a metal cover fitted by a specialist. WTZ 1110 WTZ 11320 WTZ 10290 What to do if... . . . . . . . . . . . . . . If you cannot rectify a fault yourself, please contact our after-sales service. We will always find an appropriate solution and will avoid unnecessary visits by engineers. Trust the expertise of the manufactu...