Stimmen - 5, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Alliance Laundry Systems Dateigröße: 3.79 mb Dateiname: Unterrichtssprache:

• Check the condition of the rubber door gasket for tears or holes. • Make sure drain receptacle is not clogged. • Check house plumbing. • Laundry load may be oversudsing or overloaded. Make sure you are using low-sudsing, high efficiency (HE) detergent and proper load sizes. • Make sure outside perimeter of the door glass where seal contacts glass is clean. -30 802753 Washer Symptom Possible Cause / Solution Too Many Soap Suds • Laundry load may be oversudsing. Make sure you are using low sudsing, high efficiency (HE) detergent. • Make sure you are using the amount of detergent recommended on the detergent’s label. If using non-HE detergent, use only 1/2 of the detergent manufacturer's recommended amount. • Laundry load may be overloaded. Make sure you are using proper load sizes. Vibrates/Moves Slightly • Make sure washer is level. Uneven leveling can cause vibration. • Make sure washer is installed on a solid, sturdy and level floor. The washer should not be installed on carpeting, soft tile, a platform or other weakly supported structures. • Make sure rubber feet are installed on all four leveling legs. • Try placing the washer near a corner of the room or near an external structural support wall. Is Noisy • Make sure washer is level. Uneven leveling can cause vibration. • Some sounds may be a part of normal operation for a frontload washer. Refer to Common Washer Sounds section. Load is too Wet • Wash load may be unbalanced. The washer may have limited the spin speed to prevent damage to the machine. Redistribute the load and run a RINSE & SPIN cycle. • Load is too small. Add items to make full load. Wrong Water Temperature • Make sure that the controls are properly set. • Check fill hoses. Make sure hot faucet hose is connected to hot mixing valve (indicated with “H” on the valve bracket) and cold faucet is connected to cold mixing valve (indicated with “C” on the valve bracket). • Make sure house water heater is adjusted properly. -31 802753 -32- 802753 Contact Information If service is required, contact the nearest Factory Authorized Service Center. To find the nearest service center, visit us online at If you are unable to locate an authorized service center or are unsatisfied with the service performed on your unit, contact: Alliance Laundry Systems Shepard Street P.O. Box 990 Ripon, Wisconsin 54971-0990 Phone: (920)748-3121 Date Purchased___________________________ Model Number____________________________ Serial Number____________________________ When contacting us about your washer, PLEASE GIVE THE MODEL AND SERIAL NUMBERS. The model and serial numbers are located on the nameplate. The nameplate will be in the location shown. Please include a copy of your bill of sale and any service receipts you have. If replacement parts are required, contact the source from where you purchased your washer or visit us online at FLW2173N FLW2173N Model Number and Serial Number To reduce the r...

Herunterladen

Geben Sie zwei Ziffern: