Stimmen - 2, Durchschnittliche Bewertung: 5 ( )

Hersteller: Alliance Laundry Systems Dateigröße: 3.79 mb Dateiname: Unterrichtssprache:

Cleaning Foreign Object Trap FLW2182NShock Sleeves Bolts and Lockwashers Motor Mount Hooked End of Shipping Brace Reinstallation of Shipping Materials To prevent damage while moving the unit, the shipping materials MUST be reinstalled. • Disconnect washer from electrical supply. • While supporting the front access panel, remove two screws from the bottom edge of the panel. • Gently lower the panel to remove it from the washer. • Place the shock sleeves on all four shock absorbers. Refer to the illustration below. • Insert hooked end of shipping brace into the open slot of the motor mount. • Attach the brace with the five bolts and washers. Refer to the illustration below. • Reinstall front access panel. The washer’s pump has a trap that may collect foreign objects. The trap may need to be cleaned if water is draining slower than usual. To clean: • Disconnect washer from electrical supply. • While supporting the front access panel, remove two screws from the bottom edge of the panel. • Gently lower the panel to remove it from the washer. NOTE: The pump may have some water in it. Use a rag or a container to catch water. If the wash drum is full of water, use a wet/dry shop vacuum to catch the water. • With rag or vacuum ready, unscrew the cap on the left side of the pump and remove trap. • Clean the debris from the trap. • Reinstall the trap and access panel. • Reconnect washer to electrical supply. -28 802753 Preventative Maintenance Follow these guidelines to ensure the washer operates properly. Call for service if you observe any of the following: water of any amount on the floor, an increase in operating noise or water remaining in the wash basket after a cycle. Frequency Maintenance Procedure Monthly 1. Check all hoses and the drain for leaks. 2. Check the door lock for proper operation. 3. Clean the dispenser drawer. Refer to Using Your Dispenser Drawer. 4. Check to make sure the washer is level. Every six months 1. Clean the filter screens in the fill hoses. 2. Clean the door gasket with a bleach and water solution. Every five years Have a qualified service technician conduct general preventative maintenance on the washer to ensure it operates properly. -29 802753 Troubleshooting Try these troubleshooting tips before making a service call. You may save time and money! Washer Symptom Possible Cause / Solution Won’t Fill • Make sure power cord is plugged all the way into the electrical outlet. • Make sure hot and cold water faucets are turned on. • Make sure that the fill hoses are not kinked or twisted. • Press and hold the start button for two seconds to start washer. • Make sure that the controls are properly set. • Make sure that the loading door is closed tightly. • Check the house fuse or circuit breaker. • Clean the screens in the water mixing valve and the filter screens located at the faucet end of the fill hoses. (Owner is responsible for service calls regarding cleaning of the screens.) Won’t Start • Make sure loading door is closed...

Herunterladen

Geben Sie zwei Ziffern: