Stimmen - 3, Durchschnittliche Bewertung: 3.7 ( )

Hersteller: Alliance Laundry Systems Dateigröße: 339.7 kb Dateiname: Unterrichtssprache:

Launder in hot water and chlorine bleach (if safe for fabric). Nail Polish Place face down on paper towel. Sponge with nail polish remover (non-oily) until stain disappears. Launder. Do not use nail polish remover on Acetate or Arnel fabrics. Paint Water-based — Treat by rinsing fabric in cool water while stains are still wet. Then launder. Dried paint cannot be removed. Oil-based — Pretreat with a solvent recommended on the paint container. If not available, use mineral spirits. Rinse. Pretreat with a stain remover or detergent, rinse and launder. Perspiration Rub dampened stain with detergent. Launder in hot water and chlorine bleach (if safe for fabric). If the fabric is discolored, you can try to restore it by treating fresh stains with ammonia or old stains with vinegar. Rust Apply a commercial rust remover (Whink, Rit, RoVer, etc.). Follow manufacturer’s directions and launder as usual. Scorching Launder using hot water and chlorine bleach (if safe for fabric). Fabrics can be damaged by being scorched. If this has happened, you may not be able to remove the marks. Shoe Polish Rub dampened stain with detergent. Launder in hot water and chlorine bleach if safe for fabric. Soft Drinks Rinse stain with cold water immediately. Launder in warm water and chlorine bleach if safe for fabric. Tobacco Dampen stain and rub with bar soap. Rinse. If necessary, soak in an all-fabric bleach solution. If stain remains, launder with chlorine bleach (if safe for fabric). 39091 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 17 Use and Care Stain Treatment Urine Rinse with cold water. Soak with an enzyme soaking product. Launder in hot water with chlorine bleach (if safe for fabric). If the color of the fabric has changed, sponging the area with ammonia may restore the color. Vomit Soak in a solution of one quart warm water, half teaspoon liquid hand dishwashing detergent, and one tablespoon ammonia (if safe for fabric). Soak 15 minutes. Use sponge to loosen stain. Blot with toweling. Launder in hot water (if safe for fabric) with an enzyme product. 18 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 39091 Maintenance Washer Maintenance Filter Screens Cold Weather Care If the washer is delivered on a cold day (below freezing), or is stored in an unheated room or area during the cold months, do not attempt to operate it until the washer has had a chance to warm up. Care of Your Washer Use only a damp or sudsy cloth for cleaning the control panel. Some spray prewash products may harm the finish on the control panel. Wipe the washer cabinet as needed. If detergent, bleach or other washing products are spilled on the cabinet, wipe immediately. Some products will cause permanent damage if spilled on the cabinet. Do not use scouring pads or abrasive cleansers. The washtub will need no particular care though it may need rinsing or wiping after an unusual load has been washed. This also may be necessary if too little detergent has been used. Leave the lid open to allow the inside of the washer to dry out after use. This helps prevent musty odors from developing. Replacing Hoses Hoses and other natural rubber parts deteriorate after extended use. Hoses may develop cracks, blisters or material wear from the temperature and constant high pressure they are subjected to. All hoses should be checked on a yearly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every five years. Check the filter screens in the fill hoses for debris or damage annually. Clean or replace them if necessary. If the washer is filling with water slower than normal, check the filter screens. Clean or replace them if necessary. Order filter screen Part No. F270300 from the nearest authorized parts distributor. Vacations and Extended Non-Use IMPORTANT: To avoid possible property damage due to flooding, turn off the water supply to the washer whenever there will be an extended period of non-use. 39091 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 19 Maintenance 20 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 39091 Reinstallation of Shipping Materials Shipping Brace The shipping brace in the lid opening should be saved and reinstalled whenever the washer is moved. To reinstall the brace, open the washer lid and place the brace over the washer agitator, placing the back of the brace into the washtub first. Shipping Plug The plastic shipping plug should be saved and reinstalled any time the washer is moved. The plug fits into two openings: The base opening and the shipping plug opening on the bottom of the mobile pivot dome. The plug MUST be inserted into both openings to prevent damage to the washer. In order to accomplish this, the shipping plug opening must be directly lined up with the base opening. Refer to Figure 9. Figure 9 Motor Overload Protector This internal ov...

Herunterladen

Geben Sie zwei Ziffern: