Login:
Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Anleitung Sony, modell SA-VE302

Hersteller: Sony
Dateigröße: 179.73 kb
Dateiname: 3866761121.pdf
Unterrichtssprache:enfr
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite



Dieses Gerät hat auch andere Anweisungen:

Anleitung Zusammenfassung


If howling occurs Reposition the speakers or turn down the volume on the amplifier. On placement • Do not place the speakers in an inclined position. • Do not place the speakers in locations that are: — Extremely hot or cold — Dusty or dirty — Very humid — Subject to vibrations — Subject to direct sunlight On cleaning Clean the speaker cabinets with a soft cloth lightly moistened with a mild detergent solution or water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. Troubleshooting Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If the problem persist, consult your nearest Sony dealer. There is no sound from the speaker system. •Make sure all the connections have been correctly made. •Make sure the volume on the amplifier has been turned up properly. •Make sure the program source selector on the amplifier is set to the proper source. •Check if headphones are connected. If they are, disconnect them. There is distortion in the subwoofer sound output. •Make sure the cut-off frequency on the subwoofer set to the maximum level (200 Hz) when Dolby Digital (AC-3) is on (SA-VE305 only). •Check if any sound-enhancing functions have been activated on the amplifier. If they have, turn them off. There is hum or noise in the speaker output. •Make sure all the connections have been correctly made. •Make sure none of the audio components are positioned too close to the TV set. The sound has suddenly stopped. •Make sure all the connections have been correctly made. Contact between bear speaker wires at the speaker terminals may cause a short-circuit. Specifications SA-VE505/VE502 For the U.S. model AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: with 8 ohm loads both channels driven, from 20 - 150 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.8% total harmonic distortion from 250 milliwatts to rated output. SS-MS5 (front, center, and rear speakers) Speaker system Full range . 2, magnetically shielded Speaker units 5 cm (2 in.), balance drive type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 120 watts Sensitivity level 87 dB (1 W, 1 m) Frequency range 120 Hz - 20,000 Hz Dimensions (w/h/d) Approx. 77 . 131 . 105 mm (3 1/8 . 5 1/4 . 4 1/4 in.), including front grille Approx. 131 . 125 . 113 mm (5 1/4 . 5 . 4 1/2 in.), with center speaker stand attatched Mass Approx. 730 g (1 lb 10 oz) each SA-WMS5 (subwoofer) System Speaker system Active subwoofer, magnetically shielded Speaker unit Woofer: 20 cm (8 in.), cone type Enclosure type Advanced SAW type Practical maximum output 100 W Reproduction frequency range 26 Hz - 150 Hz Inputs LINE IN (input pin jack) SPEAKER IN (input terminals) Outputs LINE OUT (output pin jack) SPEAKER OUT (output terminals) General Power requirements USA and Canada: 120 V AC, 60 Hz Europe: 220 - 230 V AC, 50/60 Hz Others: 220 - 240 V AC, 50/60 Hz Power consumptions 80 W Dimensions (w/h/d) Approx. 230 . 380 . 440 mm (9 1/8 . 15 . 17 3/8 in.), including front grille Mass Approx. 13 kg (28 lb 10 oz) Supplied accessories SA-VE505 Foot pads (16) Center speaker stand (1) Screw (for the center speaker stand) (1) Washer (for the center speaker stand) (1) Audio connecting cord (1) Speaker connecting cords, 10 m (32 ft 9 3/4 in.) (2) Speaker connecting cords, 2.5 m (8 ft 2 1/2 in.) (5) SA-VE502 Foot pads (8) Audio connecting cord (1) Speaker connecting cords, 2.5 m (8 ft 2 1/2 in.) (4) Design and specifications are subject to change without notice. SA-VE305/VE302 For the U.S. model AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: with 6 ohm loads both channels driven, from 20 - 150 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.8% total harmonic distortion from 250 milliwatts to rated output. SS-V305 (front and rear speakers) Speaker system Full range, magnetically shielded Speaker units 5 . 9 cm (2 . 3 5/8 in.), cone type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 100 watts Sensitivity level 86 dB (1 W, 1 m) Frequency range 90 Hz - 20,000 Hz Dimensions (w/h/d) Approx. 68 . 151 . 135 mm (2 3/4 . 6 . 5 3/8 in.), including front grille Mass Approx. 790 g (1 lb 12 oz) each SS-CN305 (center speaker) Speaker system Full range . 2, magnetically shielded Speaker units 5 . 9 cm (2 . 3 5/8 in.), cone type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 120 watts Sensitivity level 88 dB (1 W, 1 m) Frequency range 90 Hz - 20,000 Hz Dimensions (w/h/d) Approx. 301 . 68 . 137 mm (11 7/8 . 2 3/4 . 5 1/2 in.), including front grille Mass Approx. 1.5 kg (3 lb 5 oz) SA-W305G (subwoofer) System Speaker system Active subwoofer, magnetically shielded Speaker unit Woofer: 16 cm ...

Dieses Handbuch ist für folgende Modelle:
Sat-TV-Receiver - SA-VE502 (179.73 kb)
Sat-TV-Receiver - SA-VE505 (179.73 kb)
Sat-TV-Receiver - SA-VE305 (179.73 kb)

Bewertungen



Bewerten
Vorname:
Geben Sie zwei Ziffern:
capcha





Kategorien