Login:
Stimmen - 4, Durchschnittliche Bewertung: 4.3 ( )

Anleitung Tecumseh, modell SNOW KING LH318SA

Hersteller: Tecumseh
Dateigröße: 1.84 mb
Dateiname:
Unterrichtssprache:en
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite



Anleitung Zusammenfassung


NOTE For more information about recoil starters see "B. Engines with Recoil Starters" instructions on page 13. VIII. Transporting Your Engine !WARNING NEVER transport this engine inside another vehicle or in any enclosed space if there is any gasoline in the tank. Fuel vapor or spilled fuel may ignite. !WARNING If there is fuel in the fuel tank, close the fuel valve, if equipped, and transport the engine upright in an open vehicle, such as an open trailer or open bed of a pickup truck. If you DO NOT have an open vehicle and have to transport the engine upright in a closed vehicle, follow these steps for emptying the fuel tank before transporting: 1. Empty fuel tank by using a commercially available suction device designed for use with gasoline. !WARNING DO NOT pour fuel from engine or siphon fuel by mouth. 2. Drain fuel into an approved red GASOLINE container, being careful to avoid spilling. 3. Run the engine until remaining fuel is consumed. !WARNING NEVER leave the engine unattended when it is running and NEVER run engine in enclosed areas. Page 22 4-Cycle • Snow King Engine 181-1275-14 181-1275-14 4-Cycle • Snow King Engine Page 23 Figure 52. Snow and Debris Removal Locations 4 5 1 4 5 1 3 2 LH195SA/LH195SP 4 1 2 OH318SA/OH358SA OH195SA/OH195SP LH318SA/LH358SA 1. Oil Fill Cap/Dipstick 2. Fuel Fill Cap Areas 3. Recoil Starter/Flywheel Guard Areas 4. Linkage Areas 5. Spark Plug Connection 4 3 2 3 2 3 5 5 1 IX. Storing Your Engine A. Short-Term/Seasonal Storage I. Clean Engine Before servicing the engine remove the carburetor cover and/or blower housing. Discard dirt and debris from the following areas: • Cooling Fins • Air Intake Screen or Recoil Starter/Flywheel Guard Areas • Oil Fill Cap/Dipstick • Fuel Fill Cap Areas • Spark Plug Connection • Levers • Linkage Area • Guards • Carburetor •Head Removing debris will insure adequate cooling, correct engine speed and reduce the risk of fire. II. Fuel Storage !WARNING NEVER store engine with fuel in fuel tank inside a building with potential sources of ignition such as hot water and space heaters, clothes dryers, electric motors, etc. Failure to do so may result in an explosion and result in death or serious injury. NOTES If engine fuel stored in the gas tank and/or an approved gas container is to be unused without gasoline stabilizer for more than 15-30 days, prepare it for short-term/seasonal storage. See "IV. Fuel Treatment" instructions. Afterward, continue reading instructions below. If engine fuel is to be stored for more than one season, without gasoline stabilizer, it will gradually deteriorate. Also, if it is stored in the engine’s gas tank without gasoline stabilizer it is likely that your carburetor will have gum deposits, a clogged fuel system and WILL VOID YOUR WARRANTY. Prepare the fuel for extended storage. See "B. Extended Storage" instructions. Afterward, continue reading instructions. III. Fuel System To avoid stale gas and carburetor problems, treat the fuel system in the following method below: NOTES Tecumseh recommends using ULTRA-FRESH™ Gasoline Stabilizer as an acceptable method of minimizing formation of fuel gum deposits during storage. This product is available from your Authorized Tecumseh Servicing Dealer. Always follow mix ratio found on stabilizer container. Failure to do so may result in equipment damage. It is NOT necessary to drain stabilized gas from carburetor. IV. Fuel Treatment 1. Add fuel stabilizer according to manufacturer’s instructions. 2. Run engine at least 10 minutes after adding stabilizer to allow it to reach carburetor. !WARNING NEVER store the engine with fuel in the fuel tank inside a building with potential sources of ignition such as hot water and space heaters, clothes dryers, electric motors, etc. NOTE Instead of using a fuel preservative/stabilizer, you can empty the fuel tank as described under "I. Draining Fuel" instructions. See "B. Extended Storage" instructions. B. Extended Storage I. Draining Fuel NOTES Clean debris from engine before draining fuel from carburetor. See "I. Clean Engine" instructions. Afterward, continue reading instructions below. If you have prepared your fuel for short-term storage it is NOT necessary to drain fuel that contains stabilizer from your carburetor. See "A. Short-Term/Seasonal Storage" instructions. Afterward, continue reading instructions below. !WARNING To avoid severe injury or death, DO NOT pour fuel from engine or siphon fuel by mouth. 1. To prevent serious injury from fuel fires, empty fuel tank by running engine un...

Dieses Handbuch ist für folgende Modelle:
Schneefräsen - SNOW KING LH195SA (1.84 mb)
Schneefräsen - SNOW KING LH195SA (1.84 mb)
Schneefräsen - SNOW KING LH195SP (1.84 mb)
Schneefräsen - SNOW KING LH318SA (1.84 mb)

Bewertungen



Bewerten
Vorname:
Geben Sie zwei Ziffern:
capcha





Kategorien