Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Craftsman Dateigröße: 3.31 mb Dateiname: Unterrichtssprache:

. . Check Coolant Level (Liquid cooled models)* . . Change Coolant (Liquid cooled models)* *Every 400 Hours Check & Clean Radiator Screen (Liquid cooled models)* . Clean Engine Oil Cooler* ***. Check Engine Air Filter* ***. Check Engine Oil Level* . . . Change Engine Oil & Filter*, ** ** ***. Lubricate Tractor & Mower ***. Check Tire Pressure . Check Transmission Fluid . Change Transmission Fluid & Filter Every 400 Hours*** Check/Replace Fuel Filter (Gas)# (Diesel)**** #. ****. Clean Battery & Cables . Clean & Sharpen Mower Blades . Inspect Spark Plug(s)*(Models w/gas engines) . 20 CHECKING / ADDING FUEL Check the fuel gauge on the dashboard display (A, Figure 19) to be sure there is enough fuel to complete the job. To add fuel: 1. Remove the fuel cap (see B, Figure 19). 2. Fill the tank. Do not overfill. Leave room in the tank for fuel expansion. Refer to your engine manual for specific fuel recommendations. 3. Install and hand tighten the fuel cap. FUEL FILTER - GAS MODELS Models with Kohler engines: See Figure 21. The fuel filter is located in the fuel line between the fuel tank and the carburetor. Models with Kawasaki engines: See Figure 20. The fuel filter is located under the left rear seat deck, and is in the fuel line between the fuel tank and the carburetor. If filter is dirty or clogged, replace as follows: 1. Disconnect the negative battery cable. 2. Place a container below the filter to catch spilled fuel. 3. Using a pliers, open and slide hose clamps from fuel filter. 4. Remove hoses from filter. 5. Install new filter in proper flow direction in fuel line. 6. Secure fuel line with hose clamps. 7. Reconnect the negative battery cable when finished. FUEL FILTER - DIESEL MODELS The fuel filter assembly has a built in water separator that should be drained when the indicator light in the dashboard display turns on or once per season. Replace the fuel filter element every 800 hours of operation or as required. To drain the fuel filter: 1. Turn the engine off, set the parking brake, remove the ignition key, and wait for all moving part to stop. 2. Allow the engine and surrounding areas to cool to room temperature. 3. Place a container under the fuel filter tube and turn the base of the filter assembly (G, Figure 24) approximately 1 turn. Regular Maintenance WARNING Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills. Do not remove fuel filter when engine is hot, as spilled gasoline may ignite. DO NOT spread hose clamps further than necessary. Ensure clamps grip hoses firmly over filter after installation. Do not use gasoline containing METHANOL, gasohol containing more than 10% ethanol, gasoline additives, premium ga...

Herunterladen

Geben Sie zwei Ziffern: