Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Bradley Smoker Dateigröße: 227.87 kb Dateiname: Unterrichtssprache:

2 1 2 When installing the transformer, make sure the electrical box is located within 6' of the sink. Install the baseplate and mount the electronic box to the desired wall location. The baseplate must be mounted either level with or above the solenoid valve, and within 12" of the solenoid valve. Make sure the transformer wires (1) are positioned in the baseplate channel (2) before mounting the unit. NOTE: When positioning baseplate, make sure there is enough room for drip loops in final installation. See Note in step 7. 4 6 8 2 1 Insert smaller foam gasket (3) into strain relief. Install solenoid cable plug (1) into the smaller, telephone-style jack in the electronic box. Install faucet sensor cable plug (2) into the larger RJ-45 jack. 2 3 1 Feed the wires from the transformer through the baseplate. Connect the 1/4" spade terminal to the positive (+) terminal and connect the 3/16" spade terminal to the negative (-) terminal. Terminals are two different sizes and match corresponding terminal clips from transformer. NOTE: The faucet will automatically calibrate when sensor cable is connected and power is supplied. Refer to step 8. CAUTION: Faucet will automatically calibrate when sensor cable is connected and power is supplied. DO NOT place objects in front of collar sensor for first 30 seconds after power-up. CAUTION: DO NOT turn on water supply until all electrical connections are made. Plug the transformer into the applicable electrical receptacle. Wait at least 30 seconds, then turn on the water supply. NOTE: When power is initially supplied, the LED on the electronic box will blink and an audible indicator chirps twice per second whenever hand presence is detected. This will continue for 8 minutes and then stop. Proceed to Faucet Operation, page 6. 9/23/04 Bradley Corporation •215-1559 Rev. A; EN 04-216A Installation Instructions Aerada 1000 Series Gooseneck Faucet Installation Instructions - Electronic Battery Box (DC) Models S53-306 and S53-307 Install the baseplate and mount the electronic box to the desired wall location. The baseplate must be mounted either level with or above solenoid valve, and within 12" of the solenoid valve. NOTE: When positioning the baseplate, make sure there is enough room for drip loops in the final installation. Refer to Note in step 6. Insert smaller foam gasket (3) into the strain relief. Install solenoid cable plug (1) into the smaller, telephone-style jack in the transformer. Install faucet sensor cable plug (2) into the larger RJ-45 jack. 1 2 3 CAUTION: Faucet will automatically calibrate when sensor cable is connected. DO NOT place objects in front of collar sensor for first 30 seconds after power-up. 5 Mount the electronic box to the wall location using screw(1) and hex key provided (2). NOTE: To ensure the electronic box is level with or above the solenoid valve, the cables should create a drip loop The electronic box is designed with the wire connectors facing downward to ensure proper drip loops. 1 2 2 Remove the strain relief cover and screw (1) using hex key provided (2) . Remove foam gasket (3). Separate the foam gasket at the perforation. 1 3 2 4 Insert larger foam gasket (1). Attach strain relief cover (2) and screw (3) using hex key provided (4). 1 2 3 4 6 CAUTION: DO NOT turn on water supply until all electrical connections are made. Turn on the water supply. NOTE: When power is initially supplied, the LED on the electronic box will blink and an audible indicator chirps twice per second whenever ...

Herunterladen

Geben Sie zwei Ziffern: