Stimmen - 2, Durchschnittliche Bewertung: 3 ( )

Hersteller: EarthQuake Dateigröße: 4.34 mb Dateiname: Unterrichtssprache:

7. Reinstall spark plug. 8. Transport unit to a suitable storage location. If you have chosen to use a fuel stabilizer and have not drained the fuel system, follow all safety instructions storage precautions in this manual to prevent the possibility of fire from the ignition of gasoline fumes. Remember, gasoline fumes can travel to distant sources of ignition and ignite, causing risk of explosion and fire. 9. If there is any possibility of unauthorized use or tampering, remove the spark plug and store it in a safe place before storing the rototiller unit. Be sure to plug the spark plug hole to prevent foreign material from entering. ! WARNING dO NOT STORE TILLER IN AN UNvENTILATEd AREA WhERE FUEL FUMES MAY REACh FLAME, SPARkS, PILOT LIGhTS OR AN IGNITEd OBjECT. dRAIN FUEL OUTdOORS AWAY FROM ANY IGNITION SOURCES. USE ONLY APPROvEd FUEL CONTAINERS. 800- 45-6007 Page 15 GetEarthquake.com OPERATOR INSTRUCTIONS ANd PARTS Front Tine Models 3365_3365B_3365K_3365KPS_3365CE_3365PS_R3355H_3365PSCE TROUBLEShOOTING ANd REPAIR TROUBLEShOOTING GUIdE While normal care and routine maintenance will extend the life of your rototiller, prolonged or constant use may eventually require that service be performed to allow it to continue operating properly. The troubleshooting guide below lists the most common problems, causes and remedies. ! WARNING PRACTICE SAFETY AT ALL TIMES. ENGINE MUST BE TURNEd OFF ANd ALLOWEd TO COOL, ANd SPARk PLUG WIRE MUST BE dISCONNECTEd ANd SECUREd BEFORE ATTEMPTING ANY MAINTENANCE OR REPAIR. FAILURE TO COMPLY WITh ThIS SAFETY REQUIREMENT CAN RESULT IN SERIOUS PERSONAL INjURY TO YOU OR BYSTANdERS. PROBLEM REMEdY/ACTION Engine will not start • Add gas to gas tank. • Connect spark plug wire to spark plug. • Throttle must be positioned at choke for a cold start. Engine runs rough, floods during operation • Clean or replace air cleaner. Engine is hard to start • Drain old fuel and replace with fresh. Use gas stabilizer at end of season. • Make sure spark plug wire is securely attached to spark plug. • Drive safety control lever must be released to neutral to start the engine. Engine misses or lacks power • Raise the tines for shallow tilling by raising the depth regulator lever. • Clean or replace air cleaner. • Improper carburetor adjustment, take to authorized engine service center. • Replace spark plug and adjust gap. • Drain and refill gas tank and carburetor. Engine will not stop when throttle control is positioned at stop • See engine manual to check and adjust throttle linkage. Tiller moves forward during starting • Drive safety control lever must be released to neutral to start the engine. Tiller is difficult to control when tilling (machine jumps or lurches forward) • Lower engine speed in hard ground. • Raise the tines for shallower tilling by lowering the depth regulator lever. Belts squeal in neutral • Adjust forward belt guide: -turn engine off and allow muffler to cool -disconnect spark plug wire and secure from spark plug -pull down on drive safety control lever -manually bend forward belt guide so there is 1/16 inch or less clearance between belt guide and belt -replace spark plug wire Belts squeal in forward operation • Turn engine off and allow muffler to cool. • Disconnect spark plug wire and secure from spark plug. • Release drive safety control lever to neutral. • Adjust engage cable. • Replace spark plug wire. Excessive heat build up in transmission/tine area during tilling • Remove vegetation. • Check transmission fluid and fill if needed. Page 16 800- 45-6007 GetEarthquake.com OPERATOR INSTRUCTIONS ANd PARTS Front Tine Models 3365_3365B_3365K_3365KPS_3365CE_3365PS_R3355H_3365PSCE 65/ 65B/ 65CE/ 65k hANdLEBAR PARTS 341110927113812675 REF. NO. PART # dESCRIPTION QTY. 1 3108A CABLE ASSEMBLY W/FERREL 1 2 3170 NUT, PUSH 3/8” DIA. 1 3 3262 DRIVE SAFETY CONTROL LEVER 1 4 3268 LINK, 5-3/4” LONg 1 5 3269 HANDLE, TOP 1 6 3335 HANDLE, BOTTOM 1 7 48406 KNOB, FIVE-STAR 5/16-18 2 REF. NO. PART # dESCRIPTION QTY. 8 504 LOCKWASHER, SPRINg 5/16” 2 9 53606 NUT, HEX NYLOC 10-24 1 10 53607 NUT, HEX JAM 5/16-24 2 11 53620 SPRINg, COMPRESSION 1 12 8655 BOLT, HEX HD 5/16-18 X 1-3/4” 2 13 90141 BOLT, SFHH W/PATCH 3/8-16 X 1” gR5 4 800- 45-6007 Page 17 GetEarthquake.com Page 18 GetEarthquake.com 800-345-6007 OPERATor INSTRUCTIONS and parts Front Tine Models 3365_3365B_3365K_3365KPS_3365CE_3365PS_R3355H_3365PSCE 3365PS/3365KPS Handlebar parts REF. NO. PART # DESCRIPTION QTY. 1 1501 BOLT, SOC FLG HEX HD 5/16-18 X 3/4” GR5 4 2 2104 NUT, BI-WAY HEX LOCK 3/8-16 4 3 3108A CABLE ASSEMBLY W/FERREL 1 4 3358 MOUNT, HANDLEBAR 1 5 3359 HANDLEBAR WELDMENT 1 6 503 BOLT, HH 5/16-18 X 1-1/2” 1 7 504 LOCKWASHER, SPRING 5/16” 2 8 53606 NUT, HEX NYLOC 10-24 1 9 53607 NUT, HEX JAM 5/16-24 2 REF. NO. PART # DESCRIPTION QTY. 10 53612 LINK 11-5/8” LONG 1 11 53614 PIN, CLEVIS 1/4 X 1-1/2” 1 12 53620 SPRING, COMPRESSION 1 13 53629 BRACKET, CABLE MOUNT 1 14 53631 GRIP, HANDLEBAR 1” ID FLANGELESS 2 15 53632 NUT, PUSH 1/4” 1 16 53650...

Herunterladen

Geben Sie zwei Ziffern: