Stimmen - 4, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Shindaiwa Dateigröße: 1.71 mb Dateiname: Unterrichtssprache:

NEVER OPER- unit, always inspect and clean the ATE THE BRUSHCUTTER WITH A area of objects that could interfere DAMAGED BLADE! with or damage the blade. Y A blade-equipped unit must be Y Never use a blade near sidewalks, equipped with a bicycle-type handle- fence posts, buildings or other objects bar or barrier bar as well as a har that could cause injury or damage. ness or shoulder strap.Y Never use a blade for purposes other Y Always make sure the cutting attach- than those for which it was designed. ment shield is properly installed before operating this unit. Blade Thrust “Blade thrust” is a sudden sideways or backward motion of the brushcutter. Such motion may occur when the blade jams or catches on an object such as a sapling tree or tree stump. BE CONSTANTLY ALERT FOR BLADE THRUST AND GUARD AGAINST ITS EFFECTS! WARNING! Blade thrust can occur without warning if the blade snags, stalls or binds. Using a blade The blade rotates counter-clockwise. For best performance and to minimize being stuck by debris, move the blade from right to left while advancing on your work. Position the blade so cuts are made between the blade’s 8 o’clock and 10 o’clock positions (as viewed from above). DO NOT cut between the 10 o’clock and 5 o’clock positions. WARNING! When cutting wood with a blade, feed the blade slowly—never strike or “slam” a spinning blade against the wood. WARNING! DO NOT use 2-tooth or non- Shindaiwa approved 4-tooth cutting blades with Shindaiwa trimmers and brushcutters. WARNING! Blade thrust is more likely to .............................................................................. see the material being cut. Brushcutter Handlebar A brushcutter handlebar or barrier bar helps prevent the operator from moving forward, or the unit moving rearward, thus preventing inadvertent bodily contact with the blade. ALWAYS KEEP THE HANDLEBAR OR BARRIER BAR SECURELY IN PLACE ON THE UNIT! Brushcutter Shoulder Strap A shoulder strap provides additional protection against blade thrust. In addition, a shoulder strap gives significant support and comfort to help ensure safe and efficient operation. When operating a unit with a blade, make sure both the handle and shoulder strap are adjusted to the size of the operator using the unit. Engine Operating Speeds Operate the unit at full throttle while cutting. Best fuel efficiency is obtained by releasing the throttle when swinging back after a cut. Y To prevent possible engine damage, do not allow the brushcutter to run at high speeds without a load. Y Avoid operating the engine at low speeds. Doing so can lead to rapid clutch wear. In addition, slow-speed operation tends to cause grass and debris to wrap around the cutting head. DONOT CUT Vertical Cuts Hold the brushcutter with the blade at a 90° angle to the ground so the blade’s bottom edge rotates toward the opera- tor. Move the blade from top to bottom through the...

Herunterladen

Geben Sie zwei Ziffern: