Stimmen - 2, Durchschnittliche Bewertung: 5
(
)
)
|
Anleitung Zusammenfassung
If the enclosure is to house a propane cylinder, the tank portion of the enclosure must be ventilated according to local codes, and must not have communication with the cavity used to enclose the gas grill. The tank can not be stored below the gas grill. BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should be located as shown in the built-in instructions. Do not use hose to connect the unit. It must be connected with either rigid pipe, copper tube or an approved flexible metal connector. The installation must comply with CAN B149.1 Natural Gas and Propane Installation Code in Canada, or to the National Fuel Gas Code, ANSI Z223.1 in the United States. The minimum recommended piping size is NPS 1/2" for rigid pipe, and 5/8" OD for copper tubing (based on a 20 ft run). Longer runs may require larger sizes to conform with CAN B149.1. Natural Gas Installation Code in Canada or to the National Fuel Gas Code, ANSI Z223.1 in the United States. Built in units are supplied with a drip pan which holds only a minimal amount of grease. To prevent grease fires, the pan must be cleaned after each use. N415-0152 NOV21/06 ASSEMBLING YOUR LINER ASSEMBLING YOUR LINER STEP 4 : Attach rear panel to enclosure, fastening with (7) #8 x 1/2” tek screws. N010-0494 (BIZC450) Your liner is now ready to be mounted into your enclosure. ASSEMBLING YOUR LINER The entire installation must be leak tested prior to operating your grill (refer to leak test section of your manual for detailed instructions)....
Dieses Handbuch ist für folgende Modelle:Konvektionsöfen - BIZC450 (677.18 kb)