Stimmen - 6, Durchschnittliche Bewertung: 4 ( )

Hersteller: Vermont Casting Dateigröße: 1.41 mb Dateiname: Unterrichtssprache:

Doing so can cause severe damage to the unit and the installation area and the added risk of serious injury. Any attempt to operate these smokers on fuels for which they are not design certified voids the manufacturer's warranty. Gas Tank outlet must have Type 1 gas connection termination in order to mate with gas hose provided with smoker. The pressure regulator and hose assembly supplied by the manufacturer with the appliance must be used. Replacement pressure regulators and hose assemblies must be those specified by the appliance manufacturer. The regulator/hose assembly should be handled carefully to prevent contamination by foreign objects and dirt. The assembly should be inspected before use and any dirt or contamination should be wiped off. In order to insure proper operation, any replacement of the fuel tank regulator assembly has to be done with parts authorized by the smoker manufacturer. This unit is not to be utilized with a non-self-contained LP-gas supply system Valve/pressure regulators are factory set to the correct operating pressures. No attempts should be made to adjust these settings! Checking for Leaks After all connections are completed, check all connections and fittings for leaks with a soap solution. -With all valves closed, apply the leak check solution (50/50 mix of dishwashing detergent and water) to all gas carrying connections and fittings. -Open tank valve. Presence of bubbles at areas of wet solution indicates a gas leak. If leaks are detected or you smell or hear gas, shut off the valve and repair the leak or replace the defective part. Do not use the smoker until all leaks are corrected. When setting up the smoker and tank, it is recommended to have the tank and smoker on a line perpendicular to the wind direction. The gas hose/regulator assembly should be totally extended to the maximum distance so that the hose is straight and the tank is as far from the smoker as it can be. LP tanks are intended for operation in the upright position only. Care should be taken to protect the fuel supply hose from damage from either foot or vehicle traffic. If the appliance is not in use, the gas must be turned off at the supply cylinder and the cylinder should be disconnected from the appliance. Storage of the appliance indoors is only permissible if the cylinder is disconnected and removed from the appliance. LP Tank Not Included 18 Operating Instructions Pre-Use Procedures Your smoker has been packaged with a retail store level point-of-purchase label that hangs on the front of the door panel. This label must be removed before use. To remove the label, simply cut or tear along the indicated line and pull the top portion of the label from behind the name plate. Before you cook food in your smoker, it is important to “season” your smoker. Seasoning seals the paint and interior of your smoker to enhance flavoring, durability, and overall performance. This is also referred to as the “break-in” process. If your smoker requires any touch-up paint on the inside of the cabinet, the only time you should apply paint to the inside is before the seasoning process. Paint should not be applied to the interior of your smoker after your smoker has been used. Paint toxins may contaminate your food. However, if paint becomes necessary after use, see the section in this manual concerning After Use Care and Maintenance. To season your smoker, simply use it ...

Herunterladen

Geben Sie zwei Ziffern: