Stimmen - 5, Durchschnittliche Bewertung: 4.4 ( )

Hersteller: AT&T Dateigröße: 1.87 mb Dateiname: tl32200_QSG_i2.pdf Unterrichtssprache:

Battery installation and charging Battery installation Install the battery as shown below. Plug the battery connector securely into the socket inside the handset battery compartment, matching the color-coded label. Insert the supplied battery with the label THIS SIDE UP facing up as indicated. Align the cover flat against the battery compartment, then slide it upwards until it clicks into place. Charge the handset by placing it face forward in the telephone base or charger. The CHARGE light is on when charging. CHARGE light To replace the battery, press the tab and slide the battery compartment cover downwards. Lift out the old battery and disconnect it from the handset. Follow the instructions above to install and charge the new battery. IMPORTANT INFORMATION: Use only the supplied rechargeable battery or replacement battery (model BT166342). To order, visit our website at or call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268. Battery installation and charging Battery charging Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours of continuous charging. If the screen is blank, you need to charge the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. The screen shows Low battery until you have charged the battery without interruption for at least 30 minutes. The following table summarizes the battery charge indicators and actions to take. Battery indicators Battery status Action The screen is blank or shows Place in charger. Battery has no or very little charge. The handset cannot be used. Charge without interruption until the screen shows Low battery or HANDSET X (at least 30 minutes). The screen shows Low battery and flashes. Battery has enough charge to be used for a short time. Charge without interruption until the screen shows HANDSET X (at least 30 minutes). The screen shows HANDSET X and the battery icon shows , or . Battery is charged. To keep the battery charged, place it in the telephone base or charger when not in use. NOTES: If you are on a call in low battery mode, you hear four short beeps every 50 seconds. When you place the handset in the telephone base or charger, if no battery is installed in that handset, the CHARGE light is off and the screen shows NO BATTERY. Follow the instructions in Battery installation on page 3 to install the battery. HANDSET 1 11/20 10:30PM Battery status icon Quick reference guide REDIAL/PAUSE Press repeatedly to view the last 20 numbers dialed. While entering numbers, press and hold to insert a dialing pause. PHONE/FLASH Press to make or answer a call. During a call, press to answer an incoming call when you receive a call waiting alert....

Herunterladen

Geben Sie zwei Ziffern: