Stimmen - 5, Durchschnittliche Bewertung: 4.4
(
)
)
|
Anleitung Zusammenfassung
63-955 Traveling Recording Picture Frame/Alarm Clock Your RadioShack Traveling Recording Picture Frame/Alarm Clock combines a clock with a recorder that uses the latest IC (memory) recording technology to record sounds without tape or moving parts. You can easily see the time, and you can record an important message as well. At a time you set, you can have the recorder play the message automatically. The IC lets you record a new message as many times as you like. The clock includes these features. Large Display — lets you easily see the time and alarm settings. Built-In Photo Frame — holds a favorite picture. 10-Second Solid-State Recorder — records and plays a single message as an alarm or memo. Clock Alarm — alerts you with a repeating series of four beeps, or announces the prerecorded message. Compact Size — makes it handy to pack or carry wherever you go. PREPARATION Removing the Battery Insulation Strips Your picture frame/alarm clock comes equipped with four type 357A button-cell batteries already installed. However, before you can use the clock, you must remove the plastic insulation sheet from inside the battery compartment. 1. Use a Phillips screwdriver to remove the screw from the battery compartment cover. 2. Slide off the battery compartment cover. 3. Grasp the white plastic sheet and gently pull it off. 4. Make sure the batteries are in position, then replace the battery cover and secure it with the screw. Framing a Picture Select a picture or photograph which is thin enough to fit into the frame’s slot. Trim the picture to 25/8 . 23/8 inches (66 . 60 mm), then insert the picture from the top of the frame and push it down until it touches the bottom of the frame. Photo To replace the picture, slide it up until it clears the upper edge frame opening. © 1999 Tandy Corporation. All Rights Reserved. RadioShack is a registered trademark used by Tandy Corporation. 63-955.fm Page 2 Monday, August 9, 1999 5:39 PM OPERATION Recording A Message You can record a message up to 10 seconds long. Follow these steps to record the message. Use a straightened paper clip to press in and hold down REC. The red indicator lights. Speak into MIC from about 10 inches away in a normal voice. (Speaking too closely to MIC distorts your recording.) After 10 seconds, the recording stops automatically and the indicator turns off. To stop recording sooner, release REC. To record a new message, simply repeat these steps. The new message replaces the old one. Playing the Message To listen to the message, press PLAY. Setting the Time The clock uses the 12-hour, time format. PM appears at the left of the display for PM hours. Follow these steps to set the time. 1. Slide TIME/LOCK/ALM to TIME. 2. Repeatedly press (or hold down) HOUR to set the current hour. 3. Repeatedly press (or hold down) MIN to set the current minute. 4. Slide TIME/LOCK/ALM to LOCK. Using the Alarm Follow these steps to set the alarm. 1. Slide TIME/LOCK/ALM to ALM. The currently set alarm time, and AL appear. 2. Repeatedly press HOUR then MIN until the desired alarm time appears. 3. To have the alarm play your recorded message, slide OFF/MSG/CHIME to MSG. To have the alarm sound a series of beeps, slide OFF/MSG/ CHIME to CHIME. 4. Slide TIME/LOCK/ALM to LOCK to store your selections. To show that the alarm is turned on, appears. To check the alarm setting at any time, press HOUR or MIN when TIME/LOCK/ ALM is set to LOCK. Depending upon the alarm you selected, at the set time, the clock repeatedly announces the message or beeps for 1 minute, then turns off. To silence the alarm sooner, press ALM STOP. To turn off the alarm so it does not sound again the next day, slide OFF/MSG/CHIME to OFF. disappears. 2 63-955.fm Page 3 Monday, August 9, 1999 5:39 PM CARE To enjoy your Traveling Recording Picture Frame/Alarm Clock for a long time: • Keep the clock dry. If it gets wet, wipe it dry immediately. • Use and store the clock only in normal temperature environments. • Handle the clock gently and carefully. Don't drop it. • Keep the clock away from dust and dirt. • Wipe the clock with a damp cloth occasionally to keep it looking new. Modifying or tampering with the clock's internal components can cause a malfunction and invalidate its warranty. If your clock is not performing as it should, take it to your local RadioShack store for assistance. REPLACING THE BATTERIES Your alarm clock uses four type 357A but- ton-cell batteries (supplied) for power. When the recorded sound weakens, replace the batteries. (For the best results, use button-cell batteries available from your local RadioShack store.) The recorder keeps the last message recorded in memory while you change batteries. Follow these steps to replace the batteries. 1. Use a Phillips screwdriver to remove the screw from the battery compartment cover, then slide the cover off. 2. Use the tip of a pencil or other nonmetallic sharp object to remove the batteries. Then insert four fresh batteries in the compartment w...