Figure 6 Cut Wire Ties If Provided Locate The TV IR Cable Figure 7 Twist And Tape Figure 8 Pull To Replace Step 17. Pull the TV IR cable until the new cable is out. Unwrap the tape and discard the old cable (seeFigure 8). Step 18. Locate the Remote Control receiver through the rectangular slot and pull the cables out and cut the ends free, enough to wrap the end of the new receiver. Then fish them through the rectangular hole while pulling, to route through the frame cavity (seeFigure 9. ) Step

Remove the grate. This Remote Control Replacement Kit is to be used to replace the Reflections Electric Fireplace’s Remote Control. The kit components are shown below. (Kit Number H1454 And/Or H6977) REPLACEMENT INSTRUCTIONS Note: Depending on the type of control board in your fireplace, the number of steps and components may vary. Following are the types of control boards for identification: If you have Kit Number H1094, it will be necessary to replace the board and IR cables. In this case, com