If this happens, just press the MENU key again, and then retry your selection. Exiting Menu/Guide Mode The remote automatically times out of Menu or Guide Mode after 20 seconds of inactivity (no keys being pressed). At that time, the remote clears the displayed menu from the TV. If you want to exit the Menu Mode yourself, press the corresponding device key on the remote (TV, SAT•CBL•DTC, DVD, VCR•AUX). The ON•OFF key turns off. Advanced Functions 3 DVD Code 5 SAT•CBL•DTC Code 1 TV Code SAT CABLE

2. Set TV source to A/V input 3. Scan Channels and Auto-programming 3-1 Press the [ A /P ] button on the remote. Tuner will scan all channels in the “AIR” and “CATV” modes and memorize channels with PAL TV signal in the modes for “AIR” and “CATV”. It takes 45 and 75 seconds to scan in the “AIR” and “CATV” modes respectively. 4. Adjust the volume of Audio Output 4-1 Press the [ VOL + ] button to increase the audio volume. 4-2 Press the [ VOL - ] button to decrease the audio volume. 5. Adjust the

1. Manually turn on the device you want to control. 3. Press and hold the device key you want to program (the ON•OFF key comes on). While you’re holding down the device key, use your other hand enter the first five-digit code for your brand in the code list (the ON•OFF key goes off after the first digit). 2. Find the Code List that came with the remote. Locate the section for the type of device you’re trying to program, and find your brand in that section. Circle the codes for your brand and kee

Factory default settings are indicated by bold text. Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual. NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated. Also, No data will be indicated if a feature is not available for a particular model. Th

Twist the exposed strands. Note: The removable connectors accept up to 14 gauge wire. 2. Loosen the set screws on the volume control. 3. Connect the leads from your amplifier to the volume control set screws labeled INPUT. Make sure the LEFT L(+) and L(-) and RIGHT R(+) and R (-) wires are inserted in the appropriately marked opening. Then, tighten the screws. 4. Connect your speaker wires to the volume control set screws labeled OUTPUT, observing the + (positive) and - (negative) polarity o

Universal Remote Control Owner’s Manual RCR412BR / RCR412SR / RCR412SIR Manual del Propietario (parte posterior) SAVE THIS MANUAL AND THE CODE LISTS! Remote controls can sometimes lose their programming when you change the batteries. Make sure you keep the manual and code lists in a safe place so that you can reprogram the remote if you need to. Tip: This remote is already programmed to operate most RCA-branded TVs, VCRs, DVD players and satellite receivers. Just press the corresponding key—DVD