It is important to instruct all potential users of its proper operation. It is advised to adjust the volume control to its minimum level (Lo) while not in use and alert other users that hearing damage can potentially result from misuse. WARNING: To avoid the possibility of electrical shock, do not use this product near water (For example, near a bathtub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool) while in the bathtub or shower or when you are wet. If the p

New (un-reviewed) call information shows NEW in the display. With each new call it will automatically turn on the “New Calls / Message Waiting Indicator”, which is a small red light located on the lower right-side of the phone’s visual ringer (next to the envelope icon). NOTE: You must follow the instructions in “Set Area Code / LDS (Long Distance Service) Code” for your phone to properly recognize and dial calls out of the Caller ID stored calls (see page #27). You must program your area code s

LAST NUMBER REDIAL To redial the last telephone number you dialed, press the LNR key or dial 19. NOTES: 1. If the Hot Keypad feature has been turned off, you must first lift the handset or press SPK or MONITOR before you begin dialing. 2. Redial does not apply to intercom calls. MANUAL RETRY WITH LNR While you are on an outside call listening to a busy signal and you want to redial the same number dialed. • Press the LNR key. This will hang up your existing call and manually redial the same numb

Check the battery icon on the LCD to see the battery charge level. When replacing the batteries, always use good quality Ni-MH AAA re-chargeable batteries. Charging the Handset 1. Place the handset into the base. The LCD screen will light up and you will hear a beep to indicate charging has begun. 2. Important: Before initial operation, you should fully charge the handset for at least 15 hours. 3. After the batteries are fully charged, begin the registration process as described on page 9. When

4. The LCD shows the current Remote code. Enter the new code you would like to set up and then press the OK soft key. Remote Access You can access many features of your answering machine remotely from any touch tone phone. A four-digit security Remote code is required to access the system and the factory default code is 0000. To enter remote access: 1. Dial your phone number from any touch tone phone. 2. When the Announce1/Announce2 message starts to play, you may enter the remote access mode by

Purchase accessories for Your Clearsounds Phone: Optional Neckloop: CS-CLA7V2 (connects easily to your phone’s 2.5mm Phone Headset jack for hands-free conversations). Requires hearing aid(s) or cochlear implant(s) with t-coil(s). Optional Headset: CS-900HS (connects easily to your phone’s 2.5mm Phone Headset jack for hands-free conversations). To learn more, call ClearSounds at 1-800-965-9043 or visit 67 – ENGLISH FCC WANTS YOU TO KNOW 1. This equipment complies with Part 68 of the FCC rules and

If you want to delete the “New voice mail” text on your LCD, press the ^ in standby mode and then press and hold the key. Note: You may permanently turn off the red flashing visual indicator for both message waiting and new calls by simply setting the indicator to the OFF position (this switch is located on the underside of the telephone. CALLER ID (CID) OPERATION Reminder: Press the Back or Exit soft key from any menu to return to the previous screen. Otherwise, after 60 seconds, the phone will

4 Important Safety Instructions ............................... pg. 4-6 Location of Controls ............................................... pg. 7-9 Keys Descriptions ....................................................pg. 10 Installation Steps ..............................................pg. 11-14 BASIC TELEPHONE FUNCTIONS Amplification .....................................................pg. 14-15 Ringer Setting ....................................................pg. 16-17 Visual Indicator ..