Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
¦ Maximum Sync Transfer Rate—This option determines the maximum synchronous data transfer rate that the AAA-131CA adapter supports. The default setting is 10.0 MBytes/sec. (The effective data transfer rate is doubled when Initiate Wide Negotiation is set to Yes. For example, a transfer rate of 10 MBytes/sec becomes 20 MBytes/sec.) ¦ Enable Disconnection—This option determines whether the AAA-131CA adapter allows the SCSI device to disconnect from the SCSI bus (sometimes called Disconnect/Reconnect). The default setting is Yes. You should leave Enable Disconnection set to Yes if two or more SCSI devices are connected to the adapter. If only one SCSI device is connected to the adapter, you can set Enable Disconnection to No to achieve slightly better performance. ¦ Initiate Wide Negotiation—This option determines whether the AAA-131CA adapter attempts 16-bit data transfer instead of 8-bit data transfer. The default setting Yes. (The effective data transfer rate is doubled when 16-bit data transfer is used. For example, a transfer rate of 10 MBytes/sec becomes 20 MBytes/sec.) Configuring the AAA-131CA Adapter with SCSISelect ¦ Send Start Unit Command—This option determines whether the Start Unit Command is sent to the SCSI device at bootup (most devices do not require this). The default setting is No. ¦ Include in BIOS Scan—This option determines whether the AAA-131CA BIOS controls hard disk drives connected to the adapter. When set to Yes, the BIOS controls the hard disk drive. When set to No, the BIOS does not control the hard disk drive, and device driver software is needed to control the device. The default setting is Yes. You should leave the setting at the default for all drives that are part of an array. Additional Options Array1000CA BIOS This option determines whether the AAA-131CA BIOS is installed at boot time. When set to Enabled, the AAA-131CA BIOS is installed, and all Int13 devices are supported. When set to Disabled, the AAA-131CA BIOS is not installed. The default setting is Enabled. BIOS Support for Bootable CD-ROM This option determines whether the AAA-131CA BIOS supports booting from a CD-ROM drive. When set to Enabled, the AAA-131CA BIOS allows booting from a CD-ROM drive. r t t t t A Troubleshooting Troubleshooting Checklist Check the following if you have problems installing or running the AAA-131CA adapter and SCSI devices: ¦ Does the AAA-131CA BIOS sign-on message appear during bootup? If not, check the following items: – Is the AAA-131CA adapter properly seated in a PCI expansion slot? Refer to your computer documentation for the slot location. – Does your computer CMOS setup require you to enable PCI bus parameters (see your computer documentation)? If so, run the CMOS Setup program and assign the parameters— usually IRQ, Enable PCI Slot, and Enable Master. – Does the motherboard chipset meet the minimum requirements listed on page 1-1 (especially PCI-to-PCI bridge support)? If not, contact your vendor f...