Stimmen - 3, Durchschnittliche Bewertung: 4.7
(
)
)
|
Anleitung Zusammenfassung
Therefore, the number of hours the light will stay on will be reduced during winter. 1 BEFORE FIRST USE – Pull out to remove the clear plastic strip with orange sticker in the light fixture to charge batteries. Your new solar light’s rechargeable Ni-Cd battery is fully charged and ready for use. Install the solar light in direct sunlight. For optimum performance, it is best to charge the solar light for a FULL, SUNNY DAY. The light will turn on automatically at night. The Ni-Cd rechargeable battery provides increased brightness and stays on longer as it cycles over time (days and nights of charging and discharging). The more direct sunlight that the light receives during the day, the brighter and longer the light will stay on at night. The rechargeable Ni-Cd battery must be allowed to fully charge to operate properly. Partially charging the battery on a consistent basis will drastically reduce the life of the battery. INSTR_822-2507 Trad Tier.qxd 12/23/03 9:31 AM Page 3 ASSEMBLY INSTRUCTIONS Inspect contents of the box to ensure all parts are included and undamaged. 1 2 3 Traditional Tier Light Head Fixture Ground Stake Ground Stake Tip PARTS LIST: 1 2 3 Select a location with FULL, DIRECT SUNLIGHT. Shady locations will not allow the battery to charge fully and will reduce the hours of nighttime light. NOTE: The rechargeable Ni-Cd battery must be allowed to fully charge to operate properly. Partially charging the battery on a consistent basis will drastically reduce the life of the battery. The selected location should not be near a nighttime light source such as a porch light or street light, as these might keep the solar lights from automatically turning on. The solar lights should not be placed closer than 5 feet from one another. This could cause the solar lights to flicker from the adjacent light source. 2 INSTR_822-2507 Trad Tier.qxd 12/23/03 9:31 AM Page 4 OPERATING INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING YOUR SOLAR LIGHT. SAVE THIS MANUAL FOR FUTURE REFERENCE. Step 1 Attach the ground stake to a ground stake tip by screwing together. Push ground stake tip fully into the ground. NOTE: Ground can be softened by soaking area with water first. Step 2 Attach light head to ground stake by screwing together. The photocell light sensor should point away from other nighttime light sources. Step 3 For optimum performance, it is best to charge the solar light for a FULL, SUNNY DAY. The light will turn on automatically at night. The Ni-Cd rechargeable battery provides increased brightness and stays on longer as it cycles over time (days and nights of charging and discharging). The more direct sunlight that the light receives during the day, the brighter and longer the light will stay on at night. 3 INSTR_822-2507 Trad Tier.qxd 12/23/03 9:31 AM Page 5 IMPORTANT: The EPA Certified RBRC® Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery contained in our product indicates The Brinkmann Corporation is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC® program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8-BATTERY™ for information on Ni-Cd battery recycling and disposal bans/restrictions in your area. The Brinkmann Corporation’s involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. Top Housing Tabs Lens Battery Compartment Lid Battery Top Housing Changing Battery Step 1 Remove lens from top housing by turning lens clockwise. Step 2 With top housing upside down (solar panel facing down), push tab on battery compartment lid and remove the lid. Step 3 Remove battery. Replace with new Ni-Cd rechargeable battery. Step 4 Replace battery compartment lid. Step 5 Attach the lens by aligning the tabs with the slots in top housing. Turn counter-clockwise to lock in place. NOTE: These lights utilize L.E.D. (Light Emitting Diode) technology. There are no bulbs to replace. Cleaning It is important that the solar panel is kept free of dirt and debris. A dirty solar panel will not allow the battery to fully charge. This will shorten the life of the battery and cause the light to malfunction. Clean regularly with a dampened cloth or paper towel. 4 INSTR_822-2507 Trad Tier.qxd 12/23/03 9:31 AM Page 6 Storage Tips Troubleshooting Information Solar lights can be left outside year round, even in cold weather. However, if you wish to store your light indoors for more than two or three days, follow these steps to prevent damage to rechargeable batteries: • Store at room temperature in a dry location. • Store solar light where it can receive some sunlight or room light each day. The battery needs light to maintain a charge during storage. • During prolonged storage, units must ...