Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Axor Dateigröße: 131.56 kb Dateiname: Unterrichtssprache:

Slide EXTENSION onto ACTUATOR ROD and secure with CLIP. Slide EXTENSION onto LIFT ROD and tighten THUMBSCREW. Adjust LIFT ROD stroke for proper opening and closing of the stopper. To change direction of handle rotation, proceed as follows: Turn valve to OFF position. Remove INSERT and HANDLE SCREW. Slip HANDLE with ADAPTER off. Remove SPRING CLIP. Lift STOP WASHER, turn 90° and replace. Replace SPRING CLIP. Replace ADAPTER, HANDLE, SCREW, and INSERT. AERATOR may accumulate dirt causing distorted and reduced water flow. Remove AERATOR and rinse clean. If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90°. Plastic SCREEN in CARTRIDGE may accumulate dirt causing reduced water flow. To clean, first turn off hot and cold water supplies, then: Remove INSERT and HANDLE SCREW. Slip HANDLE with ADAPTER off. Unscrew CARTRIDGE with wrench. Thoroughly rinse plastic SCREEN at base of CARTRIDGE. Replace CARTRIDGE until flange is tight against valve body. Turn valves OFF. Replace ADAPTER, HANDLE, SCREW, and INSERT. TEE SCREW O-RING O-RING Apply a bead of PUTTY around underside of DRAIN PLUG flange. Insert DRAIN PLUG into SINK drain hole. SHANK Remove COUPLING NUT, FRICTION RING, and RUBBER FERRULE from each valve and slide onto tubing. Push TUBING ends into VALVE side outlets. Insert VALVES into mounting holes from underside of SINK. Press TEE onto SHANK of SPOUT making certain that the SHANK O-RING is properly seated on SHANK. Slide RUBBER FERRULE, FRICTION RING, and COUPLING NUT to outlet of VALVE and tighten COUPLING NUT firmly. Repeat on other VALVE. Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of right VALVE using appropriate connector. Hold DRAIN PLUG to prevent turning and assemble GASKET, WASHER, and LOCKNUT, from underneath sink. Insert threaded end of TAILPIECE into lower end of DRAIN PLUG. Connect other end to trap. DRAIN ASSEMBLY (Models 6802 and 6832 only) (Models 6801 and 6831 only) PUTTY FLANGE DRAIN PLUG RUBBER GASKET WASHER LOCKNUT SINK 3VALVE INSTALLATION (continued) M34375C HOTLINE FOR HELP For toll-free information and answers to your questions, call: 1 (800) 223-0068 Weekdays 8:00 a.m. to 7:00 p.m. Eastern Time Saturdays 8:00 a.m. to 4:00 p.m. Eastern Time Turn off hot and cold water supplies before beginning. CAUTION VALVE INSTALLATION DRAIN INSTALLATION SERVICE 1 6 2 4 LEDGE RUBBER WASHER BRASS WASHER LOCKNUT VALVE BODY 5/16'' MIN. ESCUTCHEON RUBBER RING LOCKNUT SPOUT EXTENSION CLIP CLIP LIFT ROD EXTENSION THUMBSCREW ACTUATOR ROD CARTRIDGE SCREEN SPRING CLIP STOP WASHER RETAINER RUBBER WASHER RUBBER GASKET SINK Insert BASE or SPOUT shank through center hole of SINK, making sure RUBBER GASKET is properly positioned. SPOUT OR BASE ASSEMBLY Assemble RUBBER WASHER, RETAINER, and LOCKNUT onto threads of SPOUT from underside of SINK. Insert LIFT ROD through SPOUT (or BASE) and slot of RETAINER. Align SPOUT and tighten LOCKNUT. Be sure slot in BRASS WASHER is...

Herunterladen

Geben Sie zwei Ziffern: