1.00 SRP-350II ¦ Safety Precautions In using the present appliance, please keep the following safety regulations in order to prevent any hazard or material damage. WARNING Violating following instructions can cause serious injury or death. Do not plug several products in one multi-outlet. You must use only the supplied adapter. • This can provoke over-heating and a fire. • It is dangerous to use other adapters. • If the plug is wet or dirty, dry or wipe it before usage. • If the plug does not fi

This product should not be mixed with other commercial wastes for disposal. ¦ Label Material * Control Label: PC * Other Labels: PET Rev. 1.00 - 4 - SRP-350/352plusIIA&C ¦ Introduction The SRP-350/352plusII Roll Printer are designed for use with electronic instruments such as system ECR, POS, banking equipment, computer peripheral equipment, etc. The main features of the printer are as follows: 1. High speed printing : 59 (1/6” Feed) lines per second. 2. Low noise thermal printing. 3. The data b

1.00 - 8 - 1-2-2 Parallel Interface (IEEE1284) SRP-F310/312 Pin No. Source Compatibility Mode Nibble Mode Byte Mode 1 Host nStrobe HostClk HostClk 2 Host / Printer Data 0 (LSB) - Data 0 (LSB) 3 Host / Printer Data 1 - Data 1 4 Host / Printer Data 2 - Data 2 5 Host / Printer Data 3 - Data 3 6 Host / Printer Data 4 - Data 4 7 Host / Printer Data 5 - Data 5 8 Host / Printer Data 6 - Data 6 9 Host / Printer Data 7 (MSB) - Data 7 (MSB) 10 Printer nAck PtrClk PtrClk 11 Printer Busy PtrB

In following, product specifications and/or user manual content may be changed without prior notice. Rev. 1.00 - 5 - SRP-F310/312 ■ Table of Contents 1. Setting Up the Printer...................................................................................................7 1-1 Unpacking..................................................................................................................7 1-2 Connecting the Cables................................................................

1.05 SRP-270 ¦ Table of Contents . Manual Information & Usage Precautions................................................................3 1. Content Confirmation..................................................................................................7 2. Product Part Names.....................................................................................................8 3. Installation & Usage...........................................................................................

Precaution Segment...................................................................................................................................4 1-1 Safety Precautions..................................................................................................................................4 1-2 Servicing Precaution...............................................................................................................................5 1-3 Precaution for Electrostatically Sensi

The SRP-350/352plusII also has a near-end sensor for the paper. This can give you a warning when the paper is almost out. If you find that there is not enough paper remaining on the roll when the near-end sensor is triggered, you can change the near-end sensor setting. Rotate the near end sensor tab at front or rear position. (See the below figure) 1-8 Using the Printer Control Panel 0 POWER The POWER light is on whenever the printer is on. 0 ERROR This indicates an error. 0 PAPER This light ind