Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
MB3010_3020-PNQW1644ZA-QRG-en.book Page 8 Tuesday, February 24, 2009 5:01 PM
1. Important Information
1.6 FCC and Other Information
This device complies with Part 15 of the FCC Rules.
modular plug is provided with this product. It is designed
Operation is subject to the following two conditions:
to be connected to a compatible modular jack that is also
(1) This device may not cause harmful interference, and
compliant.
(2) this device must accept any interference received,
including interference that may cause undesired
The REN is used to determine the number of devices
operation.
that may be connected to a telephone line. Excessive
RENs on a telephone line may result in the devices not
CAUTION:
ringing in response to an incoming call. In most but not
Any changes or modifications not expressly approved by
all areas, the sum of RENs should not exceed five
the party responsible for compliance could void the
(5.0).To be certain of the number of devices that may be
user’s authority to operate this device.
connected to a line, as determined by the total RENs,
NOTE:
contact the local telephone company. For products
This equipment has been tested and found to comply
approved after July 23,2001,the REN for this product is
with the limits for a Class B digital device, pursuant to
part of the product identifier that has the format
Part 15 of the FCC Rules. These limits are designed to
US:AAAEQ##TXXXX. The digits represented by ## are
provide reasonable protection against harmful
the REN without a decimal point (e.g.,03 is a REN of
interference in a residential installation. This equipment
0.3).
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
If this equipment causes harm to the telephone network,
instructions, may cause harmful interference to radio
the telephone company will notify you in advance that
communications. However, there is no guarantee that
temporary discontinuance of service may be required.
interference will not occur in a particular installation. If
But if advance notice isn't practical, the telephone
this equipment does cause harmful interference to radio
company will notify the customer as soon as possible.
or television reception, which can be determined by
Also, you will be advised of your right to file a complaint
turning the equipment off and on, the user is encouraged
with the FCC if you believe it is necessary.
to try to correct the interference by one or more of
the following measures:
The telephone company may make changes in its
— Reorient or relocate the receiving antenna.
facilities, equipment, operations or procedures that could
— Increase the separation between the equipment and
affect the operation of the equipment. If this happens the
receiver.
telephone company will provide advance notice in order
— Connect the equipment into an outlet on a circuit
for you to make necessary modifications to maintain
different from that to which the receiver is connected.
uninterrupted service.
— Consult the dealer or an experienced radio/TV
technician for help.
If trouble is experienced with this equipment, for repair or
warranty information, please contact a Factory Service
Responsible Party:
Center or other Authorized Servicer. If the equipment is
Panasonic Corporation of North America
causing harm to the telephone network, the telephone
One Panasonic Way, Secaucus, NJ 07094
company may request that you disconnect the equipment
Technical Support:
until the problem is resolved.
Panasonic Communications Company of North America
Unit of Panasonic Corporation of North America
Connection to party line service is subject to state tariffs.
Three Panasonic Way, Secaucus, NJ 07094
Contact the state public utility commission, public service
Telephone: 1-800-211-PANA (7262)
commission or corporation commission for information.
KX-MB3020 only
If your home has specially wired alarm equipment
This equipment complies with Part 68 of the FCC rules
connected to the telephone line, ensure the installation of
and the requirements adopted by the ACTA. On the rear
this equipment does not disable your alarm equipment. If
of this equipment is a label that contains, among other
you have questions about what will disable alarm
information, a product identifier in the format US:ACJ-----
equipment, consult your telephone company or a
-----.
qualified installer.
If requested, this number must be provided to the
telephone company.
WHEN PROGRAMMING EMERGENCY NUMBERS
• Registration No .....(found on the rear of the unit)
AND(OR) MAKING TEST CALLS TO EMERGENCY
• Ringer Equivalence No. (REN)
NUMBERS:
...............................(found on the rear of the unit)
1) Remain on the line and briefly explain to the
dispatcher the reason for the call.
A plug and jack used to connect this equipment to the
2) Perform such activities in the off-peak hours, such as
premises wiring and telephone network must comply
early morning or late evenings.
with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant telephone cord and
8
Detailed operating instructions are on the CD-ROM, or can be viewed at www.panasonic.com/help
...Dieses Handbuch ist für folgende Modelle:
Drucker - KXMB3020 (395.32 kb)