Stimmen - 2, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Bacharach Dateigröße: 233.79 kb Dateiname: f75264a4-4636-45b6-9d1b-a027931451a2.pdf Unterrichtssprache:

This alarm is suitable as a Single and/or Multiple Station Please take a few minutes which should be saved for future passed on to any subsequent owner. If you have any questions about operation or installation of your alarm, please call our toll free Consumer Hotline at 1-800-880-6788. WARNING: This carbon monoxide alarm is not a substitute for installing and maintaining an appropriate alarms in the house. This carbon monoxide alarm will not sense smoke, fire or any poisonous gas other than monoxide. For this reason, you must install smoke alarms to provide early warning of fire and to protect you and your family from fire and its related hazards. This carbon monoxide alarm is designed to detect carbon monoxide from any source of improper or malfunctioning appliance. The installation of this device should not be used as a substitute for proper installation, use and maintenance of fuel burning appliances, including appropriate ventilation and exhaust systems. Not suitable for installation in hazardous locations as defined in the National Electric Code. Illustration Front Back Alarm LED Amber Trouble, or Tamper Resist Feature Green Initiating Alarm LED Power Red LED Battery Compartment (Optional) AC Connector Pins Specifications Power: 120 volts AC, 60 Hz, Sensor: Electrochemical Temperature: Operating Range: 40°F (4.4°C) to 100° Humidity: Operating range: 5-95% non-condensing Alarm: 85+ dB at 10’ @ 3.4±0.5 KHz pulsing alarm Interconnection: Multiple-Station Interconnects directly with Kidde: Ion smoke alarm models: 1235, 1235CA, 1275, 1275CA, 1276, 1276CA, 1285, 1285CA Photo smoke alarm models: PE120, PE120CA, PI2000, PI2000CA Heat alarm models: HD135F, HD135FCA Carbon monoxide / Ion smoke alarm models: KN-COSM-IB, KN-COSM-IBCA; Carbon monoxide alarm models: KN-COB-IC, KN-COP-IC, KN-COB-ICB, KN-COP-ICB Relay models: CO120X, SM120X Installation This Kidde CO alarm can be used independently interconnected with The alarms should be mounted in or near recommended that you on each level of your home. When choosing your installation can hear the alarm from all sleeping areas. If you only one carbon monoxide alarm in your home, install the alarm near bedrooms, not in the basement or furnace room. Recommended Installation Locations CAUTION: This alarm will only indicate the presence of carbon monoxide at the sensor. Carbon monoxide may be present in other areas. WARNING: This product is intended for use in ordinary indoor locations of family living units. It is not designed to measure compliance with Occupational Safety and Health Administration (OSHA), commercial or industrial standards. This device is designed to protect individuals from acute effects of carbon monoxide exposure. It will not fully safeguard individuals with specific medical conditions. If in doubt, consult a medical practitioner. Individuals with medical problems may consider using warning devices, which provide audible and visual signals for carbon monoxide concentrations under 30 ppm. This alarm has not been investigated by UL for carbon monoxide detection below 70 ppm. IMPORTANT: Improper location can affect the sensitive electronic components in this alarm. Please see the next section describing locations to avoid. Installation Locations To Avoid To avoid causing damage performance, and to prevent • Do not install in kitchens, rooms that may expose the sensor to substances or contaminate it. • Do not install in areas where the than 40°F (4.4°C) or hotter than 100°crawl spaces, attics, porches and garages. • Do not install within 5-15’ of heating or cooking appliances. (Kidde recommends 15 feet to prevent nuisance alarms) • Do not install near vents, flues, chimneys or any forced/unforced air ventilation openings. • Do not install near ceiling fans, doors, windows or areas directly exposed to the weather. • Do not install in dead air spaces, such as peaks of vaulted ceilings or gabled roofs, where carbon monoxide may not reach the sensor in time to provide early warning. • Do not install on a switched or dimmer-controlled outlet. • Do not install this unit near deep cell large batteries. Large batteries have emissions that can cause the alarm to perform at less than optimum performance. • Do not obstruct the vents located on the alarm. Do not place the alarm where drapes, furniture or other objects block the flow of air to the vents. Installation Interconnecting This CO Alarm is interconnectable station Kidde and Nighthawk page 4). It is not designed to be interconnected other manufacturer’s products. • When compatible Kidde smoke and heat alarms are interconnected to your CO alarm, they will only respond to a smoke or heat related • When mixing Kidde alarms which have battery back-up with models without battery back-up, be the models without battery back-up will not during an A.C. power failure. • For alarms that are being used as single station alarms, do not connect the red wire to anything. Leave the red wire insulating cap in place to mak...

Herunterladen

Geben Sie zwei Ziffern: