Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Haier Dateigröße: 375.79 kb Dateiname: Unterrichtssprache:

Hot Rinse Drying. 15g Soak Pre-wash of dishes, pots and pans while waiting for the load to be completed after the subsequent meal. Short cold wash to prevent food residue from drying on the dishes Cycle Cycle Selection Information Description of Cycle Detergent Rinse Aid Very dirty dishes, pots and pans (not to be used with Pre-wash with cold water. Rinse with cold water. Extended wash at 50 30g Intensive Wash delicate items). Rinse with hot water Drying. Normal Wash (IEC-EN50242) Normally dirty dishes, pots and pans. Standard daily cycle. Rinse with cold water. Extended wash at 50 Rinse with hot water Drying. 25+5g For dishes that need to be Rinse with hot water rinsed and dried only. Drying. Rinse Glassware Economic, fast cycle to be used for items which are sensitive to higher. Run immediately after dishes are used. Wash at 50 . Hot Rinse Drying. 15g Soak Pre-wash of dishes, pots and pans while waiting for the load to be completed after the subsequent meal. Short cold wash to prevent food residue from drying on the dishes .9. GBGB .10. Cleaning and Filter Assembly For best performance and results, cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. is a good idea to remove the larger food particles filter after each wash cycle by rinsing the "A" semi-and cup under running water. To remove the filter assembly, on the cup handle in an upward direction. The entire filter (made up of the "A" semicircular filter and the "B" fine filter) should be cleaned at least once a month. To clean the filter and the fine filter, use a cleaning brush. Then, reassemble the filter parts as shown in the figures below and inset the entire assembly in the dishwasher, positioning in its seat and pressing downward. The dishwasher must never be used without the filters. Improper replacement of the filters may reduce performance of the appliance and damage dishes and utensils. Troubleshooting It may occur that the dishwasher does not function properly or at all. Before calling for assistance, Iet us see what can be done first: Have you forgotten to press one of the buttons or to perform an essential operation? The Dishwasher Does Not Start Have you checked whether: - the plug is pushed into the socket correctly; - the power is on in the house; - the door is closed properly; - the ON-OFF switch is on "ON"; - the water supply is turned on. The Dishwasher Does Not Load Water Have you checked whether: - the water is turned on and the hose is connected properly; - the water supply to the houses on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. The Dishes Are Not Clean Have you checked whether: - the water is turned on and the hose is connected properly; - the water supply to the house is on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. Cleaning the Spray Arms It may happen that food particles sprayer arms and block the hole (see letters C-E ). Check the sprayer arms when needed. A B Cleaning the Water Inlet Filter Periodically clean the water inlet filter located on the outlet of the water supply tap. After turning off the water tap, unscrew the end of the water supply hose, remove the filter and clean it carefully under running water. Then, return the filter to its place and tighten the water supply hose back into position. The Dishwasher Does Not Drain Have you checked whether: - the drain hose is crimped or bent. Lime Deposits or a White Film Form on the Dishes Have you checked whether: - the lid to the salt container is closed properly; - the rinse aid dosage is correct. If, despite all these checks, the dishwasher still does not function and/or the problem persists, contact the nearest authorised service agent and provide them with the following information: - the nature of the problem; - the model type number (Mod...) and the serial number (S/N...), which are indicated on the plate located on the side of the inner part of the door. Never call on unauthorised technicians and refuse to allow parts to be installed that are not original spare parts. .11. Installation Positioning the Appliance Position the appliance in the desired rest against the wall behind it, and cabinets or wall. The dishwasher is equipped and drain hoses that can be positioned to ensure correct installation. Levelling the Appliance Once the appliance is positioned, adjust the feet (screwing in or out) to adjust the dishwasher, making it level. The should not be inclined more than 2 . If the appliance is level, it will help ensure proper performance. Cold Water Connection Connect the cold water supply hose to a threaded 3/4 (gas) connector and make sure that it is fastened tightly in place (see fig. 1/A).Some models have an "Acqua stop block" water supply pipe (see fig.1/B) with filter in the threaded inlet. If the water pipes are new or h...

Herunterladen

Geben Sie zwei Ziffern: