Stimmen - 4, Durchschnittliche Bewertung: 4 ( )

Hersteller: Black & Decker Dateigröße: 651.68 kb Dateiname: Unterrichtssprache:

Sliding the switch forward (toward the Spotlight bulb) sets the Spotlight on High Beam; sliding the switch backward sets the Spotlight on Low Beam. Using the Carry Handle as a Stand For Hands-Free Operation Invert the unit to use the Carry Handle as a stand, and set it upon a flat, stable surface for hands-free operation. Using the Built-In Carry Lanyard The Carry Lanyard may be used to store or carry the Spotlight; and also allows you to position the Spotlight for convenient, hands-free operation. 5 90558474 11/25/1:20 PM Page 6 CAUTION: TO REDUCE THE • Only use the Carry Lanyard for carrying or hanging the Spotlight. Lanyard is not intended to support additional weight. Do not attach • When light is hung by the Carry Lanyard, do not shake the light or the light from electrical wires or anything CARE AND MAINTENANCE All batteries lose charge with time, especially when two months when not in frequent use, preferably using the 120 volt AC Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit with a soft cloth moistened with a mild solution of water and detergent. Battery Replacement/Disposal BATTERY REPLACEMENT The battery should last the service life of the unit. Contact Technical Support toll-free at 1-800-544-6986 for any information you may need. BATTERY DISPOSAL Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly. Recycling is required — contact your local authority for information. Failure to comply with local, state and federal regulations can result in fines or imprisonment. For more information on recycling this battery, call toll-free 1-800-544-6986. WARNINGS: • Do not dispose of the battery in fire as this may result in an explosion. • Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire). • Do not expose battery to fire or intense heat as it may explode. • For more information on recycling this battery, call toll-free 1-800-544-6986. 12 Volt DC Charging Adapter Plug Fuse Replacement The fuse in the plug end of the 12 Volt DC Charging Adapter protects the adapter’s charging circuit. If the 120 Volt AC Charger operates, but the DC charging adapter does not, then this fuse may be opened (blown) . To replace the fuse: 1. Unscrew the end cap of the DC plug (counterclockwise). 2. Remove spring center contact and fuse. 3. Check fuse with a continuity checker. 4. If blown, locate a replacement 2 amp/250 volt fuse. 5. Replace the fuse, spring, contact and end cap. 6. Screw end cap clockwise until it is finger tight – DO NOT OVER-TIGHTEN. 7. Test for proper operation of the 12 Volt DC Charging Adapter. TROUBLESHOOTING Problem Solution Spotlight will not charge (green 1. Check connection to the 120 Volt AC Charger (or DC Charging Port). Charge Status LED Indicator does 2. Check connection to AC (or DC) power source. not light) 3. Confirm there is a functioning AC (or DC) current. 4. Make sure the Trigger is not pressed (pressing the Trigger when one of the charging adapters is plugged in interrupts the charging process). 5. Make sure the Trigger Lock is not engaged. It is possible to have left the Trigger Lock ON when the battery discharged. The Spotlight will not charge until the Trigger is unlocked. 6. If the Spotlight will not charge after checking all of the above, contact Technical Support toll-free at 1-800-544-6986. 6 Problem Solution Spotlight will not operate 1. If you suspect the bulb is blown, coiled and unbroken, the bulb is not 1-800-544-6986 to locate the nearest center. The bulb is NOT user-replaceable. 2. The light may be charging/recharging using adapter. The unit will not operate while charging/recharging DC charger. Unplug from the 12 volt DC power source. 3. The battery may be completely discharged. Charge the unit following the directions in this Instruction Manual. 4. If the Spotlight does not operate after recharging as directed, Technical Support toll-free at 1-800-544-6986. Cannot depress trigger Slide Trigger Lock Button on side of handle UP to unlock the Trigger. ACCESSORIES Recommended accessories for use with your tool are available from your center. If you need assistance regarding accessories, please call: 1-800-544-6986. WARNING: The use of any accessory not recommended for use with this spotlight could be hazardous and will void manufacturer’s warranty. SERVICE INFORMATION All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you. To find your local service location, refer to the yellow page directory under "Tools–Electric" or call: 1-800-544-6986 or visit CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: Do not open body casing. Th...

Herunterladen

Geben Sie zwei Ziffern: