ATTENTION : Lire attentivement les consignes de securite et les instructions d'utilisation avant l'utilisation initiale de ce produit. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the Dehumidifier changes ownership, be sure this manual accompanies the unit. CONSERVER CES INSTRUCTIONS POUR CONSULTATION ULTERIEURE En cas de revente du deshumidificateur, ce manuel doit etre inclus avec l'appareil. Printed in China (P.R.C.) PORTABLE DEHUMIDIFIER Table of contents . . . . . . . . . . . . . . . .

1. NE JAMAIS utiliser d’essence, benzene, de peinture, diluant ou autre compose chimique pour nettoyer cet appareil; toutes ces substances feront subir des dommages ou deformations aux composants de plastique et degraderont la finition. 2. Ne jamais verser de l’eau directement sur l’appareil; ceci pourrait faire subir des dommages aux composants electriques et a l’isolant des conducteurs electriques. 3. Utiliser uniquement de l’eau tiede, un detergent pour lavevaisselle et un chiffon doux pour e

determined level. When the water tank is full and /or incorrectly positioned Utilise pour amorcer une mise en service inside the cabinet, the (water full) red light flashes and a et/ou une mise hors de service temporisee. signal (beep) sounds for 10 seconds.This condition results in the immediate shut down of the dehumidifying system. (compressor cycle terminated, however the fan motor will continue to operate) The water tank must be . F / . C Utilise pour changer les lectures de emptied and/or

: Used to adjust Clock and Timer On/Off settings backward (1 min./1hr. increments). Used to adjust Temperature settings backward (1°C / °F increments). Note: This appliance allows you select the temperature scale displayed in either “Celsius” or Fahrenheit” according to your preference. To change temperature scale displayed on the control panel display, press both the “Temp/Timer” adjust arrows simultaneously to alternate between “Celsius” & “Fahrenheit”. TIMER ON : Used to initiate the AUTO ON

The nameplate contains electrical and other technical data specific to this unit. 5) To avoid the possibility of personal injury, always disconnect the power supply before attempting to clean and/or service the unit. UNIT SPECIFICATIONS Model Number: DDR2509EE DDR3009EE DDR4009EE Dehumidifying Capacity (Pints / Liters) 25 / 11.8 30 / 14.2 40 / 18.9 Electrical Requirements 115 Volts / 60 Hz 115 volts / 60 Hz 115 volts / 60 Hz Power Input (Watts) 380 420 525 Rated Amperage (Dehumidifying) 3.8 4.2

DIRECT DRAIN NOTE: The drain hose is not included with the unit. The direct drain feature is intended FEATURE for use in basements inclusive of a floor drain only. NOTE: Do not attempt to operate the direct drain feature using drain/stem pipes above ground level. CONNECTING THE DIRECT DRAIN: 1) Remove (cut away) drain cover located at the rear of the unit (see Fig. 3) and remove the water tank located at the front of the unit. 2) Cut provided drain hose (O 13.5mm/0.53in.) to required length (to

FOR YOUR SAFETY: To reduce the risk of fire or explosion, do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. Improper connection of the equipment-grounding conductor can result in a risk of GROUNDING electrical shock. Check with a qualified electrician or service person if you are in doubt INSTRUCTIONS as to whether your appliance outlets are properly grounded. • This appliance must be grounded. In the event of malfunction or breakdo

Danby OWNER'S MANUAL MANUEL D'UTILISATION Model • Modèle DDR3008EE DDR4588EE DDR6588EE CAUTION: Read complete installation and operating instructions before installing and/or using the dehumidifier. ATTENTION : Lire attentivement les consignes de sécurité et les instructions d'utilisation avant l'utilisation initiale de ce produit. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the Dehumidifier changes ownership, be sure this manual accompanies the unit. CONSERVER CES INSTRUCTIONS

NOTE: The LED readout is programmed to default to display the ambient relative humidity conditions. To view the Set Operating Relative Humidity Value, press the “up” or “down” button (once) and the set RH operating value will flash for approximately 5 seconds in the LED window, then revert back to display the internal RH value. 2) ON/OFF Button: Each time this button is pressed the unit turns ON (adjacent indicator light illuminates) orOff (adjacent indicator light is not illuminated) 3) CONTINU