Stimmen - 4, Durchschnittliche Bewertung: 3.3 ( )

Hersteller: Bionaire Dateigröße: 140.57 kb Dateiname: Unterrichtssprache:

THERMOSTAT INSTRUCTIONS This function allows you to set the heater to your desired comfort level. The heater will maintain the desired room temperature. For BFH3405: 1. Set the THERMOSTAT knob to the highest setting, clockwise as far as it will turn. 2. When the desired room temperature level is reached, lower the thermostat setting, by turning the THERMOSTAT knob counter clockwise until it clicks. The heater will now stop operating. 3. The thermostat will now automatically maintain the pre-set temperature level by turning the heater on and off. The thermostat is now set. For BFH3410 and BFH3420: 1. To change the heater settings, press the MODE button. Each time you press the MODE button it will scroll to the settings FAN, LOW, HIGH, or AUTO. 2. Select the AUTO mode. 3. Set the heater to the desired room temperature by pressing the (+) or (-) buttons. The thermostat is now set. Note that the degree range is from 60°F - 85°F (15°C - 29°C). if you scroll past 85°F (29°C) the display will automatically loop to 60°F (15°C). NOTE: When the room temperature goes below the set temperature the heater will automatically turn off. The fan will continue to run, cooling the heater for 30 seconds. The unit will now operate when the room temperature falls below the preset temperature. . TIP: It is normal for the heater to cycle ON and OFF as it maintains the present temperature. To prevent the unit from cycling, raise the thermostat setting. OSCILLATION (For model BFH3420 only) For maximum heat distribution use the oscillation function. 1. Press the Oscillation button on the control panel to begin 90° oscillation. 2. To stop the heater from oscillating, press the Oscillation button a second time; the unit will stop in that direction. To resume oscillation, press the Oscillation button again. NIGHTLIGHT (For BFH3410 and BFH3420 only) 1. The nightlight will automatically light when the room becomes dark. When the room becomes light, the nightlight will automatically turn off. 2. To turn the nightlight off, press the button on the control panel. . TIP: The nightlight will not automatically operate until the button is pressed again. MAINTENANCE INSTRUCTIONS During Season Care Before cleaning make sure the unit is unplugged. 1. Allow the heater to cool before cleaning. 2. Carefully wipe the unit with a soft, damp cloth. . TIP: Over time, dust may accumulate on the front grills. This can be removed by wiping the unit with a damp cloth. Always unplug unit and allow to cool prior to cleaning. TROUBLESHOOTING . If your heater fails to operate: . Make sure the electrical outlet or circuit breaker is working. . Check for obstructions. If you find an obstruction turn the heater OFF, and follow the Reset Instructions in the manual. Carefully remove the obstruction. . The thermostat might be set too low. Adjust the thermostat until the heater restarts. Please DO NOT attempt to open or repair the heater. Please see the Warranty for Service Instructions. Please be cautious near the heating elements. After Season Care Store heater in a cool, dry location. Bionaire® recommends storing the ...

Herunterladen

Geben Sie zwei Ziffern: