Stimmen - 1, Durchschnittliche Bewertung: 4 ( )

Hersteller: Toshiba Dateigröße: 2.57 mb Dateiname: Unterrichtssprache:

Static electricity can damage the memory module. Before you handle the module, touch a grounded metal surface to discharge any static electricity you may have built up. To avoid damaging the memory module, be careful not to touch its gold connector bar (on the side you insert into the computer). 6 Remove the memory module from its antistatic packaging. 7 Holding the memory module by its edges so that the gold connector bar faces the slot, fit the module into the socket. 8 Gently put the memory module connector down at an angle and press down until the clips snap into place. Sample inserting the memory module Avoid touching the connectors on the memory module or on the computer. Grease or dust on the connectors may cause memory access problems. 9 Replace the expansion memory module slot cover. 10 Replace the screw and tighten it. 11 Turn the computer over and reconnect any cables you removed. 12 Turn on the computer. 13 If the computer does not recognize the memory module, shut down the computer, remove the expansion memory module slot cover, and make sure the memory module is seated properly, as described in step 8. Removing a memory module 1 Follow steps 1 through 6 in “Installing additional memory (optional)” on page 58. Do not try to remove a memory module with the computer turned on. You can damage the computer and the device. Do not remove the memory module while the computer is in Standby mode. The computer could hang up the next time you turn it on and data in memory will be lost. In either of the above cases, the Standby configuration will not be saved. The following message appears when you turn on the power: Warning: Resume Failure Press Any Key To Continue If the computer hangs up when you turn it on, perform the following: Press the power button and hold it down for five seconds, then turn the power on again. 2 Gently push the memory module locks outward until the memory module pops up. Sample removing the memory module 3 Gently pull the memory module diagonally to pull it out of the slot. 4 Complete the procedure by following steps 10 through 12 in “Installing additional memory (optional)” on page 58. Checking total memory When you add or remove memory, you can check that the computer has recognized the change. To do this: 1 Click Start, then click Control Panel. 2 Click Performance and Maintenance. 3 Click System. 4 The General tab view automatically appears and shows total memory. If the computer does not recognize the memory configuration, turn off the computer, remove the memory slot cover, and make sure the memory module is seated properly, as described in step 10 of “Installing additional memory (optional)” on page 58. Using an external keyboard If you prefer to use a full-size keyboard, you can attach one to your computer. The computer’s USB port supports any USBcompatible keyboard. Using a mouse You may want to use a mouse ins...

Herunterladen

Geben Sie zwei Ziffern: