Stimmen - 2, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
(For compressed files, please uncompress them before running a check). * This computer uses Microsoft® Windows® 95 Operating System. • Do not power off your computer or press the floppy disk drive eject button while the Write-protect Tab ten. Write Enable Write Disable First-time Operation Please read the steps below to help you learn what parts are included, and to gain an understanding of some basic computer-related operations. 1 Confirm the inclusion of all parts Make sure the parts shown in the Figure have been supplied. If any of these items are missing or is not working properly, please contact Panasonic Technical Support. Have 2HD floppy disks prepared to create disks that will allow you to reinstall I he operating system should a problem occur. Be sure that these disks are not write-protected. (It is not necessary for these disks to be preformatted.) Ç AC Adapter............................1 AC Cord.................................A CF-AA1639 Battery Pack..........................1 FIRSTAID CD.........................1 CF-VZSU04 ($) Operating Instructions.........1 Windows 95 System Pack .... 1 /о R Windows* 95 Book / J Registration Card CD-ROM j V > Connect the battery pack (5) Turn your computer over and slide the latches. (2) Lift open the cover holding both sides and remove it. ® Put a battery pack into the computer and slide the battery pack inward until it is firmly in place. (4) Attach the cover holding both sides. © Slide the latches. • Be sure the battery pack is properly connected to the connector. • Do not touch the battery connector on the computer. The computer may not operate properly. When attaching the cover; Be careful not to get your fingers caught in the cover. Connect your computer to a power outlet Be sure the AC adapter is connected until completing Step 8 on page 9. Handling the AC adapter • Do not twist or pull the AC power cord forcefully. Doing so may damage the connections. • Use only the specified AC adapter with your computer. Using an AC adapter other than the one supplied might damage the battery and/or the computer. • When the DC plug is not connected to the computer, disconnect the AC cord from your AC wall outlet. • Problems such as sudden voltage drops/surges may arise during periods of thunder and lightning. Since this could adversely affect your computer, an uninterruptible power source (UPS) is highly recommended unless the battery pack is installed. When closing the cover First insert the top of the cover, then close the cover. 7 Getting Started First-time Operation Power Switch Read the LIMITED USE LICENSE AGREEMENT (crpage 23) Before removing the seal covering the power switch, please read the LIMITED USE LICENSE AGREEMENT. Removal of this seal indicates agreement to the terms specified. After you have agreed to the terms, you may turn your computer on. Turn your computer on Slide the power switch toward the rear of the computer and hold it for approximately one second until the power indicator (^) turns on before releasing it. POSEES} • After confirming that the power indicator has turned on, do not touch the power switch until Windows setup has started. • Once the computer is powered off, you must wait at least ten seconds before powering it on again. r