Stimmen - 5, Durchschnittliche Bewertung: 3.6
(
)
)
|
Anleitung Zusammenfassung
If you encounter any problems or difficulties, please contact our Customer Service Department at: 1-310-522-9008 Por favor, guarde estas instrucciones para que le sirvan de referencia en el futuro. Si usted se encuentra con algun problema o dificultad, por favor, comuniquese con nuestro Departamento de Servicios para el Consumidor: 1-310-522-9008 2 3 2 GALLON AIR COMPRESSOR • Do not pull on power cord to disconnect it from the outlet. Keep cord away form heat, oil, and sharp edges. • NEVER move the unit by pulling on the air hose. Use the handle provided on the top of the unit. • DO NOT reach over or across running machines. • To reduce the risk of injury, close supervision is necessary when the compressor is used near children. • DO NOT ALLOW CHILDREN TO OPERATE THE COMPRESSOR AT ANY TIME. • DO NOT MAKE ANY MODIFICATIONS TO ANY OF THE COMPONENTS. Units with broken or missing parts, or without protective housings or covers in place should NEVER be operated. • Do not leave the compressor unattended while the power switch is in the “I” (ON) position. When the power switch is in the “I” (ON) position, pump motor may start at any time without warning. • Do not overpressurize tank. • If compressor has been dropped or impacted in any manner, check tank for cracks before using. • Never attempt to fill or operate compressor if any air leak is detected. • Do not modify or attempt to service tank. • Do not store liquids in tank. • This product is not intended for use as a portable breathing device or to disperse any type of liquid. • Maximum pressure: 100 PSI. Grounding Instructions: 1. This product shall be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock. 2. This product is equipped with a cord having a grounding wire with an appropriate grounding plug. 3. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances. DANGER: Improper installation of the grounding plug can result in a risk of electric shock. If repair or replacement of the cord is necessary, do not connect the grounding wire to either flat blade terminal. The wire with green insulation with or without yellow stripes is the grounding wire. 4. Check with a qualified electrician or serviceman if the grounding instructions are not completely understood, or if in doubt as to whether the product is properly grounded. Do not modify the plug provided; if it will not fit the outlet, have the proper outlet installed by a qualified electrician. Extension Cord: 1. Use of an extension cord with this product is NOT RECOMMENDED. If you must use an extension cord, use only extension cords that are intended for outdoor use. Use only extension cords having an electrical rating not less than the rating of the product. 2. Examine extension cord before use. DO NOT USE DAMAGED EXTENSION CORDS! 3. Always disconnect the extension cord from the receptacle before disconnecting the product from the extension cord. 4. WARNING – to reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch the plug with wet hands. Assembly Instructions: 1. After opening the carton, please remove all parts and check against photograph on carton. If any parts are missing, please call Alltrade at 1-800-423-3598. 2. Close the drain valve on the bottom of the air tank by turning the valve clockwise until fully closed. 3. Attach the air hose to the compressor regulator valve. Use included Teflon thread-sealing tape on the threads to make sure you have an airtight connection. Do not overtighten fittings. 4. Attach the desired accessory to the end of the hose. Use included Teflon thread-sealing tape on the threads to make sure you have an airtight connection. Do not overtighten fittings. WARNING: READ AND UNDERSTAND ALL PRODUCT FEATURES PRIOR TO OPERATING COMPRESSOR Product Features 1. AUTOMATIC ON/OFF PRESSURE SWITCH: This compressor is equipped with an automatic on/off pressure switch. The compressor will only run when the switch is in the “I” (ON) position. Once the tank has reached the desired preset pressure (see Operating Instructions), the pump motor will automatically shut off. While the switch is in the “I” (ON) position, the pump motor will automatically turn WARNING AVERTISSEM back on once the pressure in the tank drops below the minimum preset pressure. Do not leave the compressor unattended while the power switch is in the “I” (ON) position. 2. REGULATOR: The regulator allows you to select the amount of air pressure that is output through the air hose into tools and accessories. Please refer to the air delivery requirements of your tools for the proper pressure settings. 3. TANK PRESSURE GAUGE: The tank pressure gauge provides a reading of the air pressure inside of the compressor tank. 4. SAFETY VALVE: This compressor is equipped with a safety valve switch that will engage when the pressure in the tank exceeds the maximum rated pressure. ...