Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Applications include home heating systems, solar heating systems, heat recovery systems and recirculating water in domestic and commercial hot water tanks. Contact the factory for applications other than those listed, and for liquids other than water. SPECIFICATIONS INLET AND OUTLET CONNECTIONS: .” MPT or 5/8 Flare Tube Conn. Or Center Inlet Style ELECTRICAL: 809 115 Volts, 60 Hz, 1 Phase, 30 Watts, 0.3 Amps, 1600 RPM, 1/100 HP 809 HS 115 Volts, 60 Hz, 1 Phase, 80 Watts, 1.2 Amps, 3400 RPM, 1/25 HP 809 HS-815 115 Volts, 60 Hz, 1 Phase, 85 Watts, 1.4 Amps, 3400 RPM, 1/25 HP MAXIMUM LIQUID TEMPERATURE: 250.F CONSTRUCTION: Bronze, Stainless Steel, Ryton Plastic DIMENSIONS: Height over Threads 4-7/8” Width 3-3/8” Length w/1600 RPM Mtr. 6-1/2” Length w/3400 RPM Mtr. 7-1/2” CAPACITY: 809 1600 RPM 3.1 GPM Maximum and 1.8 PSI Maximum 809 HS 3400 RPM 5.3 GPM Maximum and 5.0 PSI Maximum 809 HS-815 3400 RPM 5.5 GPM and 6.53 PSI Maximum APPROVAL: Motors are U.L. Yellow Card listed, impedance protected or thermal overload Protected. Complete pump under U.L. file E80954. *UL recognition on pumps, file E80954, is for water only. INSTALLATIONS: The 809 Series pump is assembled and ready for installation. The pump should be mounted with the Electric Conduit Box (Item 15) on the bottom. The oil ports will then be on the top of the motor. The pump housing should be installed with the arrow on our housing pointing in the direction of the water flow within the system. If the arrow indicating water flow is not in the direction you require when the motor is in position, remove the four round housing screws (Item 1) holding the housing to the motor assembly and rotate the housing assembly as required. Replace the four screws and tighten. The pump is made up of two basics sub-assemblies. They are the Wet End Assembly (Items 1-10); and the Drive Magnet, Bracket and Motor Assembly (Items 11-15). To separate the 2 assemblies, simply remove the 4 round head screws (Item 1). The pump will then separate into the 2 sub-assemblies. The water will still be contained within the Wet End assembly unless you loosen the screws (Item 10) on the rear of the Wet End assembly. LUBRICATION: The motor should be oiled at least once a year at the start of the heating season with 4 or 5 drops of SAE 20 weight non-detergent oil in each bearing. If the pump is used year around it should be oiled every six months. Do not over oil. No oiling is required on the ball bearing motors. GENERAL SAFETY INFORMATION: Follow all local electrical and safety codes, and the Occupational Safety and Health Act (OSHA). Make certain that the power source conforms to the requirements of your equipment. Always disconnect power source before performing any work on or near the electric motor. Caution must be exercised to relieve any pressure in the system and in draining hot water from the pump or the system. DISASSEMBLY AND REASSEMBLY: 1—The motor assembly (Item 15) can be removed from the Wet End assembly without ha...
Dieses Handbuch ist für folgende Modelle:Pumps - Water Pump (69.04 kb)
Pumps - Water Pump (69.04 kb)