Login: Owner's Manual Model Digital Multitracker rostex «3 II il S 5 Table of Contents Introduction.........................................................6 Precautions...........................................................6 Notes about power supply.....................................................-..............6 Notes on handling the hard disk........................-..................................7 Notes on the setup location..................................................
Adjust the [TRIM] control appropriately so that the [PEAK] indicator is lit at the loudest part of playing.
When you raise the GROUP MASTER control (which corresponds to the channel INPUT fader or the track for ping-pong recording) higher than the standard level (usually "8" on the fader scale or higher; however, it depends on the equalizer setting), oscillation will occur. (The level meter will peak for the oscillating channel signal.) If you do not correct this situation and you continue to monitor the signal through the headphones or monitor speakers, unexpected oscillation noise will be output, c
2. Mix the signals recorded on tracks 1 through 6 and record the mixed signal onto tracks 7 and 8. Then tracks 1 through 6 can be used to record other materials. This is the basic technique used for Multitrackers. We recommend that tracks 7 and 8 are basically used as the destination tracks of “track bounce” from tracks 1 through 6. See “Advanced Operation” for details about the track bounce technique. In addition, tracks 7 and 8 play an important role in “training mode” and “mastering mode” des
DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Tne iighinng flash with arrownead symbol, within an equilateral triangle, is intended to alori the user to the presence of uninsulated "dangerous voltage" within me product's enclosure lhat may be of sufficient magnitude to constitute a risk ot electric shock to persons The exclamation pont withm an eauiiatera: triangle is intended to alert the user to the oresonce ot important op
Channel grouping By setting the group assign switch (1-2 or 3- 4) of a channel to ON, the channel signal is sent to group busses 1 and 2 or 3 and 4. A group buss signal is output from the [GROUP OUT] jacks. When the [ASSIGN TO STEREO OUT] switch above the group fader is set to ON, the group buss signal is output to the corresponding stereo buss. For example, it would be a good idea to assign channels for drums to a group. You can control the level of drums using the corresponding group fader wit
[INPUT SEL] Key * Set whether to send the A to H input signals [INPUT] or track 9-16 play [TRACK] sounds to the faders of channel faders 9 to 16. 26. [REC ASSIGN-BUSS-SOURCE] Key * Select the channel (SOURCE) to send to the REC BUSS during “BUSS” recording. Select the SOURCE channel with the [CH STATUS/CH SEL] key. * This key lights ON when the SOURCE is selected. 27. [REC ASSIGN-BUSS-REC TRK] Key * The track (READY) to record in “BUSS” recording is selectable when this key is flashing. Set READ
DO NOT EXPOSE THIS APPLIANCE TO RAN OR MOISTURE.'' SAFETY INSTRUCTIONS Read Instructions - All the safety and operating inductions should be read before ihe appliance is operated. Retain instructions - The safety and operating instructions should be retained Icr future reference. Heed Warnings —All warnings on tlx; applianceand in the operating instructions should be adhered 10. Follow Instructions - All operating and use instructions should be followed. Water and Moisture - The appliance s
