Stimmen - 2, Durchschnittliche Bewertung: 3.5
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
This leaflet provides supplemental information for DTX500 version 1.2. To check the version number: Press the power switch while holding down the [SHIFT] button. □TX500 ;i:® flUG-01-11 1- Version Number Trigger Setup List (page 12 of Owner's Manual) On this new version, the Trigger Setups have just updated shown below. Select the Trigger Setup according to your configuration. No. Name Kit Descriptions 1 Medium DTX500 series Drum Sets Snare: TP65/XP80/XP100SD 2 Dynamic Tom: TP65/XP70 3 500K Med for DTX500K Snare: TP65 4 500KDyna Tom: TP65 5 520K Med for DTX520K Snare: XP80 6 520KDyna (or DTX530K) Tom: TP65 7 540K Med for DTX540K Snare: XP80 8 540KDyna (or DTX560K) Tom: XP70 9 550K Med for DTX550K Snare: XP100SD 10 550KDyna Tom: TP65 11 SP Med for DTXPRESS IV 12 SP Dyna Special Drum Set 13 STD Med for DTXPRESS IV Refer to page 12 of the Owner’s Manual 14 STD Dyna Standard Drum Set 15 DT10/20 - 16 -19 UserTrg - ■ In the default setting, "1: Medium" is selected. ■ Medium (Med): Normal Setting ■ Dynamic (Dyna): Wide dynamic range. The setting is designed for maximum expressive control, allowing performance subtleties over a wide dynamic range. Excessive vibration however, may result in crosstalk (sound being produced by other pads). ■ If you use a kit other than those listed above, create your original Trigger Setup (16-19) by following the instructions on page 34 of the Owner's Manual, referring to the Pad Types described below. Pad types (page 35 of Owner's Manual) Pad types of the DTX500 version 1.2 are defined as follows. KICK KP125W/125/80S/80/65/60 DT Snare DT series drum trigger (for snare pad) SN-1 XP120SD/120T/100SD/100T DT HiTom DT series drum trigger (for small toms) SN-2 TP120SD/100 DT LoTom DT series drum trigger (for large toms) SN-3 TP65S/65 DT Kick DT series drum trigger (for bass drum) SN-4 XP80/70 misc 1-6 Other manufacturer’s pads 1 to 6 SN-5 XP120SD/120T/100SD/100T/80/70/TP65S/65 SN-6 SN-7 TM-1 TM-2 TM-3 TM-4 XP80 XP70 XP120SD/120T/100SD/100T TP120SD/100 TP65S/65 XP80/70 ■ SN-1, 2, 3, 4, 5, 6 and 7 are used as snare pads. TM-1, 2, 3, 4, 5, 6 and 7 are used as tom pads. CY-1, 2, 3, 4, 5, and 6 are used as cymbal pads. HH-1 and 2 are used as hi-hat pads. TM-5 XP80/70/TP65S/65 TM-6 XP80 TM-7 XP70 * These pad types differ in the sensitivity settings among the three sections (the CY-1 PCY155/150S/135/100/65 * Bow, Edge, and Cup sections in a 3-zone cymbal pad). You can change these as CY-2 PCY155/150S/135/100/65 * desired. CY-3 PCY155/150S/135/100/65 * The "CY-1" setting features the same sensitivity settings for all three sections. CY-4 PCY130SC In the "CY-2" setting, the sensitivity of the Edge section is fairly lower than that of CY-5 PCY130S/130 the other sections. CY-6 PCY65S In the "CY-3" setting, the sensitivity of the Cup section is fairly lower than that of HH-1 RHH135/PCY100/TP65 the other sections. HH-2 RHH130 Other Comments Executing a cymbal "choke" (gripping a cym...
Dieses Handbuch ist für folgende Modelle:Musikinstrumente - DTP520C (141.34 kb)
Musikinstrumente - DTP520P (141.34 kb)
Musikinstrumente - DTP700C (141.34 kb)
Musikinstrumente - DTP700P (141.34 kb)