Stimmen - 2, Durchschnittliche Bewertung: 4.5
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
22 Handling the Instrument The instrument is made of a thin metal so please handle it with care. Do not apply any excessive force to the instrument, or bump it in a manner that will dent or damage it. Before You Play ¦ Attaching the Screw-On Bell When attaching the screw-on bell, always hold the bell by its mid section and assemble. Do not over-tighten. ¦ Lubrication Oiling the Rotors 1. While holding the levers down, remove the valve slides then apply rotor oil to the rotors as shown in the illustration below (a few drops per rotor). * Apply oil if the lever does not work smoothly. * When applying oil, do not let the oil mix with the slide grease adhering to the valve slide’s interior. 2. Move the levers so that the oil is spread evenly. ¦ Attaching the Mouthpiece Gently insert the mouthpiece into the mouthpipe. * Never force the mouthpiece into the mouthpipe. The mouthpiece may become stuck in the mouthpipe. 23 Tuning Use the main tuning slide to make sure that the instrument is in tune before playing. Since temperature has an effect on the instrument’s pitch, blow some warm air through it to warm it up before tuning. The amount of tuning slide adjustment needed to get the horn in tune will vary between individuals so there is no standard rule to follow (however, at 68°F pulling the main tuning slide out about 0.6” should more or less tune the instrument to A=442Hz). Take notice that when temperatures are warmer, the main tuning slide should be pulled out a little more, while cooler temperatures will require that you push the slide in. Also, the position and angle of your right hand in the bell will have an influence on pitch as well. Single Horns Slide the main tuning slide in or out to tune the instrument. Double Horns 1. Use the main tuning slide to tune the Bb side. * Instruments with a Bb tuning slide should tune with the main tuning slide as well. 2. Use the F tuning slide to tune the F side of the instrument. 24 Tuning 3. Pull out each of the valve slides between 1/ 5-2/5 inch. When pulling out the slides, make sure that the lever corresponding to the slide is depressed. 4. When the hand stopping technique is used, the 4th valve on the YHR-332 lets you use regular fingerings in combination with this technique. Also, when setup as shown in the illustration below, it can be used in the same way as the 2nd valve, lowering the pitch a half-step. * What is Gestopft or hand stopping? This is a technique used on F Single or Double Horns(using F side) where the hand is placed further into the bell to raise the horn’s pitch by a half-step and change the tone of the instrument. But doing so requires the player to transpose the score down a half step to produce the correct pitch. The 4th valve on the YHR-322 compensates for the difference in pitch when using the hand stop technique, so you can read the score as is and still get the correct pitch. 25 Maintenance ¦ Caring for your instrument after playing To keep your instrument both looking and play...
Dieses Handbuch ist für folgende Modelle:Musikinstrumente - YHR-882 (6.76 mb)
Musikinstrumente - YHR-891 (6.76 mb)
Musikinstrumente - YHR-891D (6.76 mb)
Musikinstrumente - YHR-892 (6.76 mb)