Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Crate Amplifiers Dateigröße: 1.62 mb Dateiname: Unterrichtssprache:

(See page 8.) Ring = send, tip = return, and sleeve = ground. 4. PEAK/SIGNAL LED: This LED will illuminate green when a signal is present at the High or Low Z inputs. When the signal nears clipping, the LED will illuminate red. (See Gain control, #5.) 5. GAIN: Use this control to set the input signal level for the channel. Adjust this control so the peak LED (#4) flashes on strong signal peaks. 6. HIGH: Use this control to adjust the high frequency level for the channel. This control allows for 15dB of cut or boost at 10kHz. Typical equalization diagrams are shown on page 7. 7. MID: Use this control to adjust the midrange frequency level for the channel. This control allows for 15dB of cut or boost at 2kHz. Typical equalization diagrams are shown on page 7. 8. LOW: Use this control to adjust the low frequency level for the channel. This control allows for 15dB of cut or boost at 100Hz. Typical equalization diagrams are shown on page 7. 9. AUX 1, AUX 2: Use these controls to set the channel’s output signal level at the aux 1 and aux 2 send jacks (#17, page 5). These are pre-EQ, pre-fader, and are typically used as monitor sends. Examples of some typical connection methods are shown on pages 8–13. 10.AUX 3, AUX 4: Use these controls to set the channel’s output signal level at the aux 3 and aux 4 send jacks (#17, page 5). These are post-EQ, post-fader, and are typically used as effects loop sends. Examples of some typical connection methods are shown on pages 8–13. 11. PAN: Use these controls to set the amount of the channel’s output signal sent to the left and right master faders (#30, page 6) and the left and right balanced output jacks (#15, page 5). 12.MUTE: This switch, when depressed, mutes the channel’s output signal sent to the left, right and mix master faders (#30, 31, page 6). 13.PFL: This switch, when depressed, sends the channel’s post-EQ, pre-fader signal to the headphones jack (#28, page 6) and the PFL output jack (#18, page 5). 14.FADER: Use this control to set the channel‘s signal level output sent to the left, right and mix master faders (#31, 32, page 6) and the aux 3 and aux 4 send jacks (#17, page 5). 5 The Master Section: 15 16 18 17 20 22 25 26 24 27 28 29 30 31 32 23 21 19 15. LEFT, RIGHT AND MIX BALANCED OUTPUTS: Use these jacks to send the mixer’s output signal(s) to the house power amplifier(s) (see pages 9–13). For the XLR jacks, pin 2 = “+,” pin 3 = “–,” and pin 1 = shield. For the 1/4” jacks, tip = “+,” ring = “–,” and sleeve = shield. 16. TAPE IN/TAPE OUT JACKS: Use these jacks to connect to the record and playback jacks of a cassette tape deck. Because the tape in jacks are fed directly into the left and right master faders, use the tape deck’s output level control or an in-line attenuator to adjust the level of the playback signal. 17. AUX SEND JACKS: Use these jacks to send the aux signals to your monitor amps and/or external effec...

Herunterladen

Geben Sie zwei Ziffern: