Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Hersteller: Marshall Amplification Dateigröße: 289.55 kb Dateiname: Unterrichtssprache:

Choose the desired parameter with the Write (“UP”) & Cancel (“DOWN”) Buttons and use the Value Knob to adjust the parameter value. Note: A list of effect parameters can be found in the aforementioned effect chart in the rear of the manual. This will be very helpful in determining which parameter is being adjusted. Tip: The Original Value Indicator (small dot in the lower right corner of the Program/Value Display) can be used to indicate the saved effect parameter settings of the currently selected program. Simply put, when the Original Value Indicator is lit, the previously saved effect parameter setting has been selected. E EEx xxa aam mmp ppl lle ee ( ((a aal lll ll A AAX XX5 55 m mmo ood dde eel lls ss) )) 1. Select MOD with the Function Knob. 2. Use the Write (“UP”) & Cancel (“DOWN”) Buttons to select “F2” (CL Flange). Then use the Value Knob to adjust the CL Flange effect’s Main parameter (SPEED). 3. Turn the Function Knob clockwise one position to PARAM. Use the Write (“UP”) & Cancel (“DOWN”) Buttons to select “P2” (DEPTH). Use the Value Knob to adjust the level of the DEPTH parameter. Note: In this mode, if you press the Program Up (Value) switch, the current parameter value will be displayed. If you press the Program Down (Type/Param) switch, it will display to the currently selected FX type/parameter. S SSa aav vvi iin nng gg a aa P PPr rro oog ggr rra aam mm You’ve tweaked and turned some knobs, and you like the changes that you’ve made – now to save your program: 1. Set the Function Knob to the “WRITE” position, and press WRITE (“UP”) Button. A User program number will blink in the Program/Value Display. 2. Use the Program Up and Down Switches or Value Knob to select the destination program number (1 - 40) 3. Press the WRITE (“UP”) Button once again, and your program will be stored in the specified location (“CP” will display briefly indicating the process is complete). A AAm mmp pp/ //L LLi iin nne ee S SSe eet ttt tti iin nng gg ( ((A AAX XX5 55G GG o oon nnl lly yy) )) The AX5G’s output may be optimized to suit specific monitoring sources via the Amp/Line setting. Amp/Line settings can be made under the P5 parameter of the Drive/Amp (Note; the amp line setting is only applicable to Amp models {i.e. A0, A1, A2, A3, etc.} and will not be found on Drive models {i.e. D0, D1, D2, D3, etc.}). Select “A1” if you connect the AX5’s output to the input of a clean-sounding open back combo. Select “A2” if you connect the AX5’s output to the input of an open back combo with stronger mid-range content. Select “A3” if you connect the AX5’s output into a sealed back cabinet such as an amp stack. Select “Ln” if you connect the AX5’s output into a line input such as a mixer, recorder, headphones or any other full range monitoring source. 3 AX5-Series EasyStart Q QQu uui iic cck kk A AAs sss ssi iig ggn nn - --A AAs sss ssi iig ggn nni iin nng gg a aa s ssp ppe eec cci iif ffi iic cc e eef fff ffe eec cct ...

Herunterladen

Geben Sie zwei Ziffern: